Switchable Exhaust, anyone tried these?
Discussion
Has anyone given these a go?
Have a near new system on the car and I couldn't get the Wortec Exhaust when I was living in Aus. Might be an alternative for tunnel blasting.
www.pfyc.com/pc/GN5018/GTEXH/Quick+Time+Low+Profile+Oval+Electric+Exhaust+Cutout.html
cv8gto said:
Has anyone given these a go?
Have a near new system on the car and I couldn't get the Wortec Exhaust when I was living in Aus. Might be an alternative for tunnel blasting.
www.pfyc.com/pc/GN5018/GTEXH/Quick+Time+Low+Profile+Oval+Electric+Exhaust+Cutout.html
Had those on mine for the last couple of years..............make sure you get the electronic controller then you can vary the amount of noise.........easy fit as well. Got mine from Nemesis UK....

OK
Had a look at the Vid here and I have to have a pair
www.quicktimeperformance.com/
With the prices I am going to get them from the States.
Had a look at the Vid here and I have to have a pair
www.quicktimeperformance.com/
With the prices I am going to get them from the States.
This looks interesting too. Keep your Maf and run it straight into the Maggie, tempted to see how it runs
www.pfyc.com/pc/GT3009/GT/Vararam+Cold+Air+System+for+2005+2006+GTO.html
www.pfyc.com/pc/GT3009/GT/Vararam+Cold+Air+System+for+2005+2006+GTO.html
Very cool..... but is anyone not concerned about heat management? Is the hot exhaust gas not going to wreck the underneath of the car?
The intake on the other hand looks pretty impressive:
http://www.youtube.com/watch?v=l7KNkjvhQvo
I know its a Camaro, but its an LS3, the gains look good..... Skip to 1:00 to avoid the Yanky B.S.
The intake on the other hand looks pretty impressive:
http://www.youtube.com/watch?v=l7KNkjvhQvo
I know its a Camaro, but its an LS3, the gains look good..... Skip to 1:00 to avoid the Yanky B.S.
Edited by scarebus on Sunday 11th April 08:21
May be tempted by these myself.....would think heat would be an issue only if the car is stationary for long time for example on a hot day, in the pic there is insulation over the cutout as well ...a lot of street class drag cars have open headers that exit under the floor....I think to be legal the exhaust gases must exit the cars bodywork but come mot time ect just run em shut.
Glyn84 said:
cv8gto said:
ferb said:
scarebus said:
BULK BUY ? ? Come on you know it makes sense!
:scatchchin:
If there is a bulk buy then I am in!

Me too I think! Didn't think louder than Wortec was possible but that sounds lovely

Oh yes
with the units fully open just behind the cats its almost like having open headers....if there was room (chassis rail in the way) I was going to make a side exit!.........just be sensible and use them in the right place, or we will all be banned!!Don't forget guys that if you're going down this route you need to plan where to put the units. I found the best place is to replace the aftermarket cat section of your system with cat bypass pipes with the units added in. If you're doing a bulk buy speak to someone like AAS in newcastle and get them to fabricate cat delete pipes on a bulk order basis.
Gassing Station | HSV & Monaro | Top of Page | What's New | My Stuff




