Heavy rumble at speed?
Discussion
The otherday I noticed what sounded like a heavy rumble at speed this only happend at around 90 MPH then stopped if my speed dropped down even increased a little. The steering was rock steady and I have just fitted two new rear tyres which were balanced. Is it possible the prop shaft may need to be balanced? or do all Monaros do this?
Regards John
Regards John
mfp4073 said:
The otherday I noticed what sounded like a heavy rumble at speed this only happend at around 90 MPH then stopped if my speed dropped down even increased a little. The steering was rock steady and I have just fitted two new rear tyres which were balanced. Is it possible the prop shaft may need to be balanced? or do all Monaros do this?
Regards John
Check your rear wheelnuts for starters.Regards John
mfp4073 said:
The otherday I noticed what sounded like a heavy rumble at speed this only happend at around 90 MPH then stopped if my speed dropped down even increased a little. The steering was rock steady and I have just fitted two new rear tyres which were balanced. Is it possible the prop shaft may need to be balanced? or do all Monaros do this?
Regards John
Regards John
No car should do that!
It could be wheels or the prop. As you have just changed the tyres, it sounds like a starting point.
scarebus said:
Mr Monkfish..... can propshafts be balanced? I still have vibrations on my r8, I have balanced all wheels but it still rumbles above 45mph, and seems to be coming from rear end... Ta
Yes, but it wont be the balance.
If its not wheels, which it probably is despite the balance (see our web page on this subject!) then it could be prop related, either the drive donuts or, more expensively the spigot mose bush in the gearbox tailshaft.
Maybe a wheel bearing?
I could advise which with a test drive.
MyM8V8 said:
Most high volume tyre shops knock their kit around something terrible and they won't be bothered about a fine balance either.
In fairness most main stream tyre shops are dealing with "normal" sized wheels from yonder years ( where balancing "normal" tyres needed much less fuss ). 18" was considered huge some years back. The calirabtion of these machines used has a fairly large range to stay within certified spec.
If you can accelerate through any wobble/judder then it will noramlly be end of line balancing which is the wheels, and in some cases can even be closer to the end of line balancing, and be the tyre itself.
And as per quote above , most dealers do the bare minium to keep their equipment insurance safe , let alone make them perform better. I should know I've serviced enough of them. I can spend 15 minutes just cleaning them up so they move and work properly!
Gassing Station | HSV & Monaro | Top of Page | What's New | My Stuff


