SLP Oil Pump setup
Discussion
MadMaxHSV said:
Anyone use one of these? Is it a good idea to fit the stiffer pressure relief valve spring to bump the pressure or is this unecessary/cause any problems?


I think the extra volume is more important. The extra pressure could play havoc with your seals. Unless advised otherwise by an expert, I'm not fitting the high pressure spring in mine.
Havoc with what seals ? There arent any seals on an LS engine that are under pressure.
Apart from the oil filter seals themselves, and if you want to call them seals, the front and rear cam plates.
Amazingly, even the damn oil pump doesnt have a seal where it meets the block !
I just used a standard pump, although did shim it slightly. Dont run huge amounts of pressure though.
Strangely, the standard GM pump did appear to already have been ported when I opened it up. Maybe just newer OE pumps are like that ?
Apart from the oil filter seals themselves, and if you want to call them seals, the front and rear cam plates.
Amazingly, even the damn oil pump doesnt have a seal where it meets the block !
I just used a standard pump, although did shim it slightly. Dont run huge amounts of pressure though.
Strangely, the standard GM pump did appear to already have been ported when I opened it up. Maybe just newer OE pumps are like that ?
ARAF said:
If some of the engines have a habit of firing the dipstick out of the block when cold, then this is one place where additional pressure may not be wanted.
Firing the dipstick out is crankcase pressure...not oil pressure.In no way whatsoever could oil pressure ever force the dipstick out.
Blowby and inadequate crankcase ventilation could though.
MyM8V8 said:
stevieturbo said:
the oil filter seals themselves, .
Dont run huge amounts of pressure though.
[quote]
Edited by MyM8V8 on Saturday 1st May 17:08
I would think hundreds of psi, as Ive seen plenty of engines of all shapes and sizes make 100+psi when cold and never damage the filters.
While you've got the sump off to do your pump, take a look at the 90 degree drillings for the filter relay pipes (front sump). Mine were in a dreadful state from the factory CNC - need to port these out to get good flow to and from the filter. IMO, much more of a problem than the OEM machine work on the pump...
iacs_hsv said:
While you've got the sump off to do your pump, take a look at the 90 degree drillings for the filter relay pipes (front sump). Mine were in a dreadful state from the factory CNC - need to port these out to get good flow to and from the filter. IMO, much more of a problem than the OEM machine work on the pump...
Great positive help & advice Paul.
MadMaxHSV said:
Well its on, kept to stock pressure.
As a side note, the Edelbrock two piece cover does not fit with this pump (even with plenty of grinding/clearancing)
Thanks for all the advice
I got the QTP billet item. A lot dearer but a good piece and looking more like the stock cover shape. Do hope mine fits OK.As a side note, the Edelbrock two piece cover does not fit with this pump (even with plenty of grinding/clearancing)
Thanks for all the advice

stevieturbo said:
MyM8V8 said:
stevieturbo said:
the oil filter seals themselves, .
Dont run huge amounts of pressure though.
[quote]
Edited by MyM8V8 on Saturday 1st May 17:08
I would think hundreds of psi, as Ive seen plenty of engines of all shapes and sizes make 100+psi when cold and never damage the filters.
Gassing Station | HSV & Monaro | Top of Page | What's New | My Stuff


