De-Badge
Author
Discussion

Lewis07-Hitman

Original Poster:

948 posts

222 months

Thursday 20th May 2010
quotequote all
Want to de-badge a VXR8. Who here has done it? Any recommendations?
Cheers in advance.

Magic919

14,591 posts

232 months

Thursday 20th May 2010
quotequote all
Many of us. Warm sun and some floss or similar. Then some spirit to get the remaining glue off. No secret knack.

keelan85

215 posts

199 months

Thursday 20th May 2010
quotequote all
Using a hairdryer also works well, you just need to get the glue soft.

boggie

393 posts

253 months

Thursday 20th May 2010
quotequote all
I de-badged to re-badge two weeks ago. The Monaro badge was not straight so I got a new one. As it was quite a warm day I simply got a length of floss and dragged it through behind the badge to garrotte it from the car. You only really need the hairdryer trick when it is cold and the Monaro badge is stuck down with double sided foam tape which makes the job even easier. I then cleaned the area with a sponge and soapy water before using T-Cut to clean up any residue. Took about 5 minutes in total.

Easy Peasy!

gsd2000

11,515 posts

214 months

Thursday 20th May 2010
quotequote all
be careful with t-cut its a fairly harsh polish, i would use something like autoglym glue and tar remover from halfords, to remove any glue and residue left from the badge.

SOCO

227 posts

203 months

Thursday 20th May 2010
quotequote all
WD40 is good for getting rid of the stubborn bits of adhesive that get left behind when the badges come off.

Lighter fuel is perhaps less risky than spirit for cleaning up afterwards. It's also good for preparing paintwork before putting on new badges or stickers, not that it applies in your case.

the_ferret82

25,627 posts

215 months

Thursday 20th May 2010
quotequote all
Lighter fuel is very good at removing them and there sticky marks. so is Autoglym tar remover.

ARAF

20,759 posts

254 months

Thursday 20th May 2010
quotequote all
Don't use lighter fluid if you're having a fag though. hehe

Autoglym Super Resin Polish also gets the glue off.

As to new badges, I have a roll of double sided foam. It's a lot cheaper to reuse the old badge. biggrin

scarebus

858 posts

202 months

Thursday 20th May 2010
quotequote all
Ummm dont do what I did and use a screw driver! Biggest mistake of my ownership banghead

marksx

5,174 posts

221 months

Thursday 20th May 2010
quotequote all
scarebus said:
Ummm dont do what I did and use a screw driver! Biggest mistake of my ownership banghead


ouch!

mogv8

836 posts

259 months

Thursday 20th May 2010
quotequote all
As stated by others, floss and either lighter fluid or meths + . Weather is warm this weekend so should help.

Patience is the big thing though, dont rush it.

Granby

2,473 posts

246 months

Thursday 20th May 2010
quotequote all
Maplins do spray can of label remover which i've used many time and works a treat smile

kelz Vxl

13 posts

198 months

Thursday 20th May 2010
quotequote all
Boiling water from the kettle to take the badges off then tar and glue, what my other half done for all the cars we have had he doesnt like badges lol

drew ss

2,683 posts

215 months

Thursday 20th May 2010
quotequote all
kelz Vxl said:
Boiling water from the kettle to take the badges off then tar and glue, what my other half done for all the cars we have had he doesnt like badges lol



wd-40 takes it off as well as tar and no it dosent f the paint work

wilsog1

10 posts

240 months

Sunday 23rd May 2010
quotequote all
Just leave your car near some dodgy school and all the badges disappear quite quick. I should know I have the scratches to prove it and, I'm sure Ive seen a VXR Saxo trolling round Deeside. Interestingly enough, the police wouldn't come and look for finger prints as it had been raining and they said they will be washed off, but I haven't washed my car since and there seems to be a lovely set of prints 'developing' on the boot spoiler. I think I'll give them a ring. Makes a change me harassing them

SOCO

227 posts

203 months

Sunday 23rd May 2010
quotequote all
I can't speak for police forces outside the met police but I can't submit fingerprints to the fingerprint branch from the exterior of vehicles in cases of theft or criminal damage. As much as police would like to take a chance in court it's the Crown Prosecution Service who have the last word and they'd never take it to court. They say that anyone could have touched it in the street.

The argument is that it only proves that they touched your car, not that they stole your badges and caused a whole lot of expensive repairs. What I've written here does not necessarily reflect my own opinion.

Fingerprints don't wash off with rainwater but you can't leave prints on a wet surface.