WARNING! The Horn Is Imminent.
Discussion
Magic919 said:
Warm sun is usually enough. You can prise it off with your fingers if you are sensible. Bit of floss under one edge to get it started. Then some solvent to remove any remainder of the glue/foam.
I used a bit wire from ma strimmer lol worked it in behin the badges and it cut throw the foam pads that hold them on. Ofcourse the wire was not attached 2 the strimmer at the when did it lol. The some solvent and to remove the worst of the foam pad left behind then some tar and glue remover worked a treat

gsd2000 said:
ARAF said:
That's cleaner. Did you use strimmer wire? and how did you hold the strimmer to use it without scratching the paint?
hairdryer and dental floss works well and doesnt scratch the paintGot about six inches of floss and just worked it back and forth.
Broke about three times but removed in the end.
Then got off the remaining sticky stuff with the hairdryer and a rubber glove.
A toffee wheel would have been quicker but I don't have one!
I really like the clean look.
I intially left the VXR8 badge, but that went as well in the end.
I am using the same PH design on the wheel centres to finish it off. (REALLY confuse folk!)

Just spent the afternoon changing the brake fluid as Picador forgot to do it and I couldn't be arsed taking it back plus I know it's been done properly.
Also cleaned and polished the calipers and wheels at the same time.
Edited by MEATANDCHEESE on Tuesday 15th June 19:43
Gassing Station | HSV & Monaro | Top of Page | What's New | My Stuff






