AC control wiring

[Sagi Badger]

After either part of the wiring diagram or tech advice as to how to "fool" the pressure and temperature sensing on the AC.

I am using the AC clutch feed to energise a solenoid on a non AC Sagaris. I have opened the podmenu and selected AC on etc, but now at ignition/countdown to launch get an error code for the AC. I have played with the trinary switch wiring, linking out pairs at arms length, incidentally this triggers one of the fans so must be the temperature sensing (4pin plug). There is also a two pin connector in the same area, NS wing by headlight.

Any ideas?

Cheers, J

[VARLEYHYD]

Alternatively use the water control valve wiring that is bundled up under the water temp sensor.

This is easy to get at back of pod just run two new wires for a supply

If this is of use to you, I will check my records for the terminals numbers;
Think it maybe easier than trying to use the ac wiring?

G