T350 hub centre size ? New wheels....

[gacksen]

Hi there,

reading for some time now but can´t find a proper answer to verify.
What i know is of course the 5x114,3 and the corresonding ET42 / ET33 on the
front and rears. What is missing is the diameter of the hub ? Is it 71,56mm ?

Cheers

Gerd

[EvoOlli]

That's right. Bearing Hubs are from Jeep Cherokee's, so 114.3 / 5 and 71.5 center.

[gacksen]

thx for the info currently on the hunt for some decent wheels

Cheers

Gerd

[Laser Sag]

A lot of japanese cars use the correct PCD so can be an idea to look at what is available for their drift cars.

[gacksen]

got lost meanwhile on different JAP sites really nice stuff but the price
is way off. almost like getting some BBS LM´s adapted from porsche. dont want to
go the OZ route that would be the easy fix.

[Laser Sag]

Have a look at Rota wheels, have the Rota Torques as the summer wheels on the Sag, lighter and stronger and sensible money.

[gacksen]

Really nice ones the only problem on the T is the offset on the front of ET42. There is a lot of stuff available with ET30 but i am quite worried they will stuck out too much as they come out 1,2cm and the goodyear tires are way higher on the edges as the toyos. I guess an easy fit would be 8x18 ET37 and rears 9x18 ET35. Maybe on the rears 9x19 ET38 should fit also but i am not sure.

[Laser Sag]

I went with the 18 x 8.5 ET35 for the front and 18 x 9.5 ET35 for the rear and have had no problems with rubbing or bottoming out even when 2 up and loaded with luggage etc for a 2 week holiday through France. I can't comment on what it would be like on the T350 though.

[gacksen]

i dont know the exact differences either the prob on the jap wheels could be a clear swing and miss if they dont fit as it would be a blind buy.... ok of course almost a lot can be measured out on the front i dont think there is much room for anything else than 8x18 ET37. almost exact 1 to 1 replacement for the spider. the rear could be either a 9x18 ET 29 or ET 35. Would need to measure the distance between the wheel and the damper. if there is more space than 1,5cm to the inner side a ET29 would fit as it is comming out 1cm more than the spider and should be fine with 255/35/18 on the rear. Do you have a side view with the rotas on ?