Window gap

[optimax sniffer]

We've just had a new passenger window fitted to the Tamora by auto glass.

Whilst out yesterday we noticed that the glass doesn't meet the roof along its complete length, giving a gap of 2-3 mm, which obviously give a fair ammount of wind noise.

Is it easy / possible to raise the glass position, or is the glass undersize?

[craigcaf]

Depending where you are located, try Glassman here on PH. Paul just did a great job on the T350C windscreen and has done a number of TVRs. He's based around North London / Essex.

C

[ninetynine]

if you take the door card off you will see 2 brackets front and rear
window can be adjusted on these also sometimes possible to move the glass slightly
on clamp at bottom
to take door card off remove 3 screws under bottom of door and pull card out at bottom then lift up

[Buzz Billsberry]

ninetynine said:

if you take the door card off you will see 2 brackets front and rear
window can be adjusted on these also sometimes possible to move the glass slightly
on clamp at bottom
to take door card off remove 3 screws under bottom of door and pull card out at bottom then lift up

Ditto that...it's straight forward

Buzz

[T350 Al]

As above; fairly straight forward job! Get the door card off and it'll all be fairly obvious. That said, if you need a hand I'm always available (though a bit further away in Chepstow nowadays!) as I've taken apart the doors more times than I care to remember!

Cheers,

Al