Drive shaft length?

[gmw9666]

Hi all

Just dropping in from the classic section. I'm building this = http://www.pistonheads.com/gassing/topic.asp?h=0&a...

And in the pile of bits I got these new drive shafts. Question for you, they look about 50cm so want to know if they are normal length or the longer sagaris versions?

[VARLEYHYD]

Sagaris drive shafts 20" long excl cv's

Be aware if they have been used they must be fitted same LH& RH side otherwise they are likely to break due to stress reversals.

GV

[gmw9666]

VARLEYHYD said:

Sagaris drive shafts 20" long excl cv's

Be aware if they have been used they must be fitted same LH& RH side otherwise they are likely to break due to stress reversals.

GV

These are brand new. So at 50cm overall it sounds as though they are "not" the longer sag ones, would that be correct?

[VARLEYHYD]

gmw9666 said:

These are brand new. So at 50cm overall it sounds as though they are "not" the longer sag ones, would that be correct?

Agreed, they are likely NOT to be Sagaris

Yellow paint on the cap screws was used by TVR to indicated torqued up correctly so may have come from a part built car

[gmw9666]

VARLEYHYD said:

Agreed, they are likely NOT to be Sagaris

Yellow paint on the cap screws was used by TVR to indicated torqued up correctly so may have come from a part built car

Got these codes on it, tried to match them using the internet but zippo came up