Speedo Pod Blanking
Speedo Pod Blanking
Author
Discussion

coach

Original Poster:

1,110 posts

273 months

Thursday 2nd March 2006
quotequote all
Tis I again - him of a thousand questions

My the display blanks out on the pod after about 30-60m of journey. Pull over, "re-boot" car - all is fine.

The pod was repaired for an unreadable display at the factory about 2 weeks ago but this is a different fault

Any ideas apart rip the little bugger out and send off agian?

Coach

chris watton

22,545 posts

281 months

Thursday 2nd March 2006
quotequote all
If it's still covered under a warranty, I would insist that the whole pod (and maybe even ECU) be changed for new ones (the mileage just need to be calibrated in the new parts - I went through roughly the same this time last year, but a heater flap issue)The ECU seems to control everything, and when it goes on the blink, it's a bloody nightmare!

T66ORA

3,474 posts

278 months

Thursday 2nd March 2006
quotequote all
The main pod ECU is in the drivers foot well, half way up to the right, it has been known to get damp/wet when it rains, also there is a large multi-plug on top of it, i would just make sure it is connected properly before condemning the pod itself.

coach

Original Poster:

1,110 posts

273 months

Thursday 2nd March 2006
quotequote all
Thankyou

I feel an upside down in the driver footwell moment coming on!

I shall try that at the weekend

Coach