Start up proceedure?
Start up proceedure?
Author
Discussion

W111AAM

Original Poster:

668 posts

262 months

Thursday 30th November 2006
quotequote all
Recently when I turn the ignition on my Tamora the start up procedure doesn’t go as it should! Usually, the rev counter and the speedo swirl around, and then the 3 lights flash on in turn. However recently, occasionally the rev and speedo counters with spin, but only the first 2 lights flash on. The display doesn’t come up and them the warning tone comes on and stays on until you switch the ignition off again.

When I turn the key a second time, it usually works fine. Is it just the cold weather play with the electrics or should I be more worried!

icraigmy

1,653 posts

253 months

Thursday 30th November 2006
quotequote all
I get this sometimes. When I start the engine for the first time from cold, sometimes the dispaly does not come on. When I back the car out of the garage, turn the engine off, and then restart, the display reappears.

I think it maybe a cold reset fault with the ECUscratchchin

lukesr

166 posts

252 months

Thursday 30th November 2006
quotequote all
I get this all the time, i just turn it off and on again and its all fine. Just take it on the chin and think of it as part of the uniqueness of own a TVR