Tamora Door Adjustment
Discussion
madbadger said:
Ow do.
Undo the bolt with a peg spanner. When it is loose you can move it about. If you lower its position then tighten back up it should raise the door a bit.
Might take a bit of trial and error.
Undo the bolt with a peg spanner. When it is loose you can move it about. If you lower its position then tighten back up it should raise the door a bit.
Might take a bit of trial and error.
And which bolt might that be then? or are you going to show me on Sunday? Cheers Andy.
ntel said:
madbadger said:
Ow do.
Undo the bolt with a peg spanner. When it is loose you can move it about. If you lower its position then tighten back up it should raise the door a bit.
Might take a bit of trial and error.
Undo the bolt with a peg spanner. When it is loose you can move it about. If you lower its position then tighten back up it should raise the door a bit.
Might take a bit of trial and error.
And which bolt might that be then? or are you going to show me on Sunday? Cheers Andy.
I can show you Sunday.
It is the brass door latch. The bit on the door rather than the body. There are two holes in the round plate bit that the peg spanner goes in.
madbadger said:
ntel said:
madbadger said:
Ow do.
Undo the bolt with a peg spanner. When it is loose you can move it about. If you lower its position then tighten back up it should raise the door a bit.
Might take a bit of trial and error.
Undo the bolt with a peg spanner. When it is loose you can move it about. If you lower its position then tighten back up it should raise the door a bit.
Might take a bit of trial and error.
And which bolt might that be then? or are you going to show me on Sunday? Cheers Andy.
I can show you Sunday.
It is the brass door latch. The bit on the door rather than the body. There are two holes in the round plate bit that the peg spanner goes in.
I see now. However, I think the problem is with the hinges rather than the latch.
Gassing Station | Tamora, T350 & Sagaris | Top of Page | What's New | My Stuff



