Replacing rear T350 badge
Replacing rear T350 badge
Author
Discussion

thainy77

Original Poster:

3,347 posts

227 months

Saturday 22nd December 2007
quotequote all
Can somebody tell me how to do it please, i've had a quick look but if anyone could tell me how they did theres it would be much appreciated.

Thanks in advance.

kevin63

4,661 posts

282 months

Saturday 22nd December 2007
quotequote all
Not sure if it same as the Cerbera or not, but I peeled the carpet back and just un did the two locking nuts and that's it.

mattybrown

331 posts

239 months

Saturday 22nd December 2007
quotequote all
Its easy...

Open the compartment in the boot.

Put your hand up in the compartment and you will feel two bolts.

Remove the bolts and the badge will come away.

Then replace with new badge in reverse of above...

Some tinkering is needed with the button, but it is pretty obvious.

Took me about 5 minutes.

T5SOR

2,030 posts

254 months

Saturday 22nd December 2007
quotequote all
Could you take some pics of the badge fitted to the T350? I only have ones fitted to the Sag

mattybrown

331 posts

239 months

Saturday 22nd December 2007
quotequote all
T5SOR said:
Could you take some pics of the badge fitted to the T350? I only have ones fitted to the Sag
Mike

I will try and take some tomorrow... and e-mail them to you.

Thanks

Mathew




thainy77

Original Poster:

3,347 posts

227 months

Sunday 23rd December 2007
quotequote all
Thanks for that and thanks for the badge Mike, spot on.

cramorra

1,689 posts

264 months

Monday 24th December 2007
quotequote all
And to mention that rubber seals originally fitted by TVR must have cost 0.002 P and therefor will be either not present or missing already, same goes for springs....

mattybrown

331 posts

239 months

Monday 24th December 2007
quotequote all
Mike

I have sent the pics. Hope they are OK.

thainy77

Original Poster:

3,347 posts

227 months

Tuesday 12th February 2008
quotequote all
I've finally got round to replacing my rear t350 badge and cannot figure out how to do it still!! has anyone got any pics? i've taken off the fibre resin light cover that runs along the rear of the boot but i cannot see the bolts that hold it in place. HELP!!

LJM

241 posts

249 months

Tuesday 12th February 2008
quotequote all
You've made the same mistake as me then!! There is no need to remove the light cover...If you have one rear speaker then you can do it the same as me.

Simply remove the grill from the speaker, then remove the 4 retaining screws.

If you then look through the hole you can just about see the bolts holding the badge on.

You can then undo these using a small ratchet or ratchet spanner. Not the easiest job in the world but shouldn't take to long....Infact the hardest part for me was refitting the speaker because the carpet is so thick.

HTH,

Lloyd

thainy77

Original Poster:

3,347 posts

227 months

Tuesday 12th February 2008
quotequote all
Perfect! thanks alot mate. thumbup