help with seat width
Discussion
Morning all,
Sorry to bother but would any one happen to know the measurements of a standard 350,Tam or Sag seat (any kind will do) I am looking to fit the Cobra carbon fibre seats available for T350s but could do with making sure they will fit - Cobra think they should as chassis is similar and I have seen 350 seats in Griffs. Of particular interest is the width of the shoulder wings as this looks the widest part. Many thanks for reading this and any help appreciated
Regards
Stilly
Sorry to bother but would any one happen to know the measurements of a standard 350,Tam or Sag seat (any kind will do) I am looking to fit the Cobra carbon fibre seats available for T350s but could do with making sure they will fit - Cobra think they should as chassis is similar and I have seen 350 seats in Griffs. Of particular interest is the width of the shoulder wings as this looks the widest part. Many thanks for reading this and any help appreciated
Regards
Stilly
Hi Nick,i've just done a quick measure of one of my Sag seats for you.I've got 460mm at the outward protrusions near shoulder height,480mm at the widest point of the lower part of the backrest,and 510mm at the widest part of the base which is near the front.I hope this makes sense and also helps a bit
.All measurements are obviously approximate,and taken roughly with a tape measure and my 40 year old eyesight!!
.All measurements are obviously approximate,and taken roughly with a tape measure and my 40 year old eyesight!!Other restriction to be aware of is the width of the base at the front of the seats, which I believe will foul the trans tunnel unless you have seat fully back (same on Griff as T350) or are happy having seat facing outwards a bit!
Cobra did simple fix for my T350, they cut down about 4" length of a flange on front of each seat before fitting the covering.
Cobra did simple fix for my T350, they cut down about 4" length of a flange on front of each seat before fitting the covering.
Thanks for the replies Mike and Tailslide - was begining to think that Griff owners were not welcome on T car pages!
Tailslide, how are you finding your seats comfort wise? I went to Cobra to try them out and they are bloomin tight! Marc at Cobra was very helpful as you have said previously - I just have to see how much room my roll bar takes up as I have the seat right back currently and this will not be possible with new bar installed.
Thanks again for your help and advice both of you.
Regards
Stilly
Tailslide, how are you finding your seats comfort wise? I went to Cobra to try them out and they are bloomin tight! Marc at Cobra was very helpful as you have said previously - I just have to see how much room my roll bar takes up as I have the seat right back currently and this will not be possible with new bar installed.
Thanks again for your help and advice both of you.
Regards
Stilly
Gassing Station | Tamora, T350 & Sagaris | Top of Page | What's New | My Stuff