oops to much oil seems to be bubbles on dip stick
oops to much oil seems to be bubbles on dip stick
Author
Discussion

Neil20

Original Poster:

49 posts

231 months

Sunday 20th July 2008
quotequote all
Hi
Got back from longish run yesterday checked oil ,looked like really low ,so topped up just checked again today after short run and know its way over max approx 1 inch.
Also seems to be bubbles on dipstick.

Should i drain some off if so how?
Any advice would be greatly appreciated.
many thanks neil (numpty)

Edited by Neil20 on Sunday 20th July 18:00

puckrup

472 posts

229 months

Monday 21st July 2008
quotequote all
Should be OK, SP6 engine will just burn off excess if slightly over-filled. Done it once myslef, no issues. N

Neil20

Original Poster:

49 posts

231 months

Monday 21st July 2008
quotequote all
thanks

Targarama

14,785 posts

312 months

Monday 21st July 2008
quotequote all
Its dry sump, so there can't be too much oil in the engine (unless the scavenging pump has failed), only the oil tank. Not a problem.

tail slide

2,169 posts

276 months

Monday 21st July 2008
quotequote all
puckrup said:
Should be OK, SP6 engine will just burn off excess if slightly over-filled. Done it once myslef, no issues. N
Apart from.... in rapid cornering eg a roundabout, if above max mark some oil will be sucked up vent tube into air filter, not ideal but will gradually seep out again down the air inlet duct.

For trackday enthusiasts on sticky tyres you need oil to be half-way between max & min, or same thing happens if corner enthusiastically rolleyes

Neil20

Original Poster:

49 posts

231 months

Monday 21st July 2008
quotequote all
thankyou thought i'd have to suck it out,will the bubbles reduce in time?

tail slide

2,169 posts

276 months

Monday 21st July 2008
quotequote all
Neil20 said:
thankyou thought i'd have to suck it out,will the bubbles reduce in time?
Personally, I'd remove it. Had to do this at Pembrey track few months back through a tube..... vomit

Buy a turkey baster to suck up, or even cheaper a few metres of large CLEAR plastic tube (eg 20mm wide) from DIY/fish supplies shop, then you can see it before it gets too close!

astonman

839 posts

239 months

Monday 21st July 2008
quotequote all
Has anyone tried capping off the original inlet box orifice and simply venting the dry sump tank to an overflow vessel to prevent excess oil ending up in the inlet box.?

Neil20

Original Poster:

49 posts

231 months

Tuesday 22nd July 2008
quotequote all
thanks tallslide i tried it last night but it took ages as the tube was to small.
Off down to DIY shop to get bigger tube today.

mnat thanks neil

Leadfoot

1,918 posts

310 months

Tuesday 22nd July 2008
quotequote all
Why not just drain some off using the plug at the bottom of the oil tank?


tail slide

2,169 posts

276 months

Tuesday 22nd July 2008
quotequote all
Leadfoot said:
Why not just drain some off using the plug at the bottom of the oil tank?
yes ... if yours has one.

TVR_owner

3,349 posts

220 months

Tuesday 22nd July 2008
quotequote all
Or use a turkey thingy?

BP-TVR

45 posts

218 months

Tuesday 22nd July 2008
quotequote all
I did the same thing a while back. A turkey baster at 99p did the trick. Just sucked out from the tank about 50-75 ml at atime into a jar held next to the tank till enough removed.

Neil20

Original Poster:

49 posts

231 months

Tuesday 22nd July 2008
quotequote all
thanks all just done it with a bit of tube.


thanks again for all the repsonses much its appreciated.

neil