T350T Wipers

[Andyt25]

Do all T350 wipers rub against the bonnet when on..infact they just don't rub they push the bonnet up...Can the bonnet be adjusted

Edited by Andyt25 on Sunday 16th August 19:38

[the jollyrodger]

i know mine dont!

[grumbledoak]

Mine don't. (T350C, technically, but that doesn't matter).

[Andyt25]

Technically T350T but not to worry..

Edited by Andyt25 on Sunday 16th August 21:15

[SP6 Animal]

Yes the bonnet can be adjusted but so can the wiper arms.

[the jollyrodger]

IMO,far better to do the wiper arms than the bonnet!

[Andyt25]

the jollyrodger said:

IMO,far better to do the wiper arms than the bonnet!

Cheers all....wipers is it....It's a potential buy and just wanted to make sure it could be done...

[Andyt25]

Just speaking to Forza West TVR specialist and they said some do some don't. It all depends on how the bonnet came out of the mould. They had a Tuscan that was getting fff engine at taht also did the same with ther wipers which couldn't be sorted.

[BatleyBoy]

SP6 Animal said:

Yes the bonnet can be adjusted but so can the wiper arms.

I have this problem. Can you tell me how the wiper arms can be adjusted?
Thanks. BB.

[SP6 Animal]

BatleyBoy said:

SP6 Animal said:

Yes the bonnet can be adjusted but so can the wiper arms.

I have this problem. Can you tell me how the wiper arms can be adjusted?
Thanks. BB.

Assuming your arms are the same as mine.
When in park position remove allen bolt mark arm and body with marker pen.
Clean out splines with pointed tool and repostion don't force make sure splines line up nip up bolt and check bonnet clears wiper arm.
You can check to see how much you have moved it with marked line.

[Nagra]

SP6 Animal said:

Assuming your arms are the same as mine

[Aowhs102]

My wipers were doing this on the Tam a little while ago, admitedly a different bonnet but same wipers presumably. Turns out it was a bit loose, I just took an allen key to the top of them, gave it a few turns and the problem went away.

[< FORZA WEST]

After a few whacks with a hammer all is now good......Only joking .

Took the wiper assembly off and reseated it, for whatever reason the nearside was a few mm too high, thus pushing the arm up into the bonnet. There is now a gap for the wiper arm to move in.

Now to finish the service

[Andyt25]

Cheers Stu...if any one could sort it I new it would be you.....Now for service, hope there are no nasty suprises as hope to get the car for the weekend.

[< FORZA WEST]

Nothing exciting to report, Sorting the rattle/buzz from the exhaust system and just waiting for the n/s front wheel to come back from refurb, then its done on my end.

[Andyt25]

Great news Stu...then you can get on with all those rebuilds...Cheers mate.

[SP6 Animal]

[quote=< FORZA WEST]Nothing exciting to report, Sorting the rattle/buzz from the exhaust system and just waiting for the n/s front wheel to come back from refurb, then its done on my end.
[/quote]
Umm what was the outcome have a similiar noise.

[< FORZA WEST]

Im looking at the exhaust in the morning so i'll let u know whats the cause