Oil TEMP sensor - where is it?
Discussion
Yup, it can. Some oil loss is inevitable, however, so have some spare handy. The new sensor does NOT come with a replacement washer so you have to be johnny-on-the-job to fit the old one to the new sensor first. Easiest on a ramp, obviously. Tighten - remembering the sensor is hollow brass - car back down and top up. Simple!
Hmmm, how accurate are these sensors? I've covered mine over with a protective rubber sleeve to stop wind chill, but it barely gets above 70C unless its in traffic. Same with water temp sensors too, which seem to under-read. Can they be reset/reconfigured or is it just best to replace?
Geoff Ashcroft said:
Hmmm, how accurate are these sensors? I've covered mine over with a protective rubber sleeve to stop wind chill, but it barely gets above 70C unless its in traffic. Same with water temp sensors too, which seem to under-read. Can they be reset/reconfigured or is it just best to replace?
I don't know? Mine reads approx 25 deg low. This morning when I started her up, oil temp was -19 deg!Its always read low but its getting worse! Time to replace it me thinks.
Cheers for the advise on replacement Mad Wud - I'll try and pick up a washer too.
Edited by L33 on Friday 19th March 17:18
Gassing Station | Tamora, T350 & Sagaris | Top of Page | What's New | My Stuff





