ECU 3 pin connector - where the **** is it!

[Jim_w]

Evening all,

I seem have one of the few T350s with a working OBD connector. However I have had to hack this because I haven't got the connector. I do however have the 3 pin lead and before I order an ODBC plug I thought I'd try the 3 pin lead. Problem is I cannot find it anywhere. I have searched all the threads but still can't locate it. I have found a 2 pin connector ( 2 black wires) which I think is a redundant fault finder lead, I also have a lead which has the 3 pin plug on it but doesn't come from the ECU ( splices into the multiplug loom - red/black/pink&purple wire) and doesn't work if I connect to the laptop. It is next to the dash ecu.

So question is where is this 3 pin connector? Suggestions welcome even if it is just which area of the loom I should check.

Cheers Jim

The headaches are getting worse........

[SapphireBlack]

Jim

TVR POWER have the odb style connector leads, I bought one from them a while back.

Conor

[shpub]

Tucked up at the front of the fuse box in the drivers well. Usually cable tied out of the way.

[cinquecento]

Taken from the floor of the drivers side looking vertically up.

[Jim_w]

thanks for all the help and especially the photo - this confirms I don't have the 3 pin connector in my car or it is very well hidden. will stick to the ODBC. Hopefully my Ecu water sensor will come tomorrow and I can go out and play.

Cheers Jim

[Jim_w]

thanks for all the help and especially the photo - this confirms I don't have the 3 pin connector in my car or it is very well hidden. will stick to the ODBC. Hopefully my Ecu water sensor will come tomorrow and I can go out and play.

Cheers Jim