Bad day for Carbon Fibre Front Splitter :(
Bad day for Carbon Fibre Front Splitter :(
Author
Discussion

stimshady

Original Poster:

1,323 posts

217 months

Sunday 29th September 2013
quotequote all
Just been away for the weekend, drove into the place with no problems and on leaving, a metal gate stop in the floor has ripped through the front of my carbon splitter.

not happy.

any idea what a replacement cost is going to be?

Edited by stimshady on Sunday 29th September 14:20

CatalystV12V

893 posts

211 months

Sunday 29th September 2013
quotequote all
Sorry to here that frown

If memory serves me correctly, they're 3k-4k. There's a thread on this somewhere. I'm sure someone was looking in to whether it was feasible to make a cheaper replacement... Don't recall whether it came to fruition...


stimshady

Original Poster:

1,323 posts

217 months

Sunday 29th September 2013
quotequote all


banghead

Henry M

74 posts

222 months

Sunday 29th September 2013
quotequote all
Last I heard the Vantage Collection was going to make a carbon fiber front splitter like yours. Contact them to see what their timeline is.

Henry

V8 Animal

6,015 posts

240 months

Sunday 29th September 2013
quotequote all
I feel for you I worry about catching mine too so often it looks like I have abandoned the car as there's a big gap at the front when ive parked it!

Lunablack

3,494 posts

192 months

Sunday 29th September 2013
quotequote all
Well that puts my kerbed wheel into perspective.....mad

KarlFranz

2,008 posts

300 months

Sunday 29th September 2013
quotequote all
Astonmartinbits.com has a new one for £2050.96 here:
http://astonmartinbits.com/models/8-V12-Vantage/pa...

They also have a refurbished one for £1200:
http://astonmartinbits.com/models/8-V12-Vantage/pa...

You can also replace it with the plastic, non-carbon version from the V8V for only £400:
http://astonmartinbits.com/models/8-V12-Vantage/pa...

V8 Animal

6,015 posts

240 months

Sunday 29th September 2013
quotequote all
When I bought my car it had a small chip in the splitter which the garage had repaired for me not as big as the OP but it may get repaired at the right garage?
Call to the dealers Monday?
Mine was repaired by Chartwell Derby smile

divetheworld

2,565 posts

165 months

Sunday 29th September 2013
quotequote all
Must have been a high bollard!!

There is a maximum height for speedhumps and probably a generally accepted level of clearance which most mass market cars will generally be fine with. If the obstacle is above this height and there is no signage would I say there was any chance of a claim?

CatalystV12V

893 posts

211 months

Sunday 29th September 2013
quotequote all
stimshady said:


banghead
The stuff of nightmares ... I worry about mine all the time. I never go over speed humps, just not worth the risk.


stimshady

Original Poster:

1,323 posts

217 months

Sunday 29th September 2013
quotequote all
Thanks for all the comments and links to parts.

No chance for a claim I don't think. We hired a big country home for my Mum's 60th.

I spotted the metal step on the way in,(it's the bit in the middle that gates close against) but it didn't look high enough to cause any damage, slightly uphill on the way in, went over it fine.

On the way out, I was careful to approach it slowly but it must have been due to the slight down hill angle and the car being in gravel that it just caught.

A hard lesson learned frown

I will have it mended a.s.a.p., already spoken to dealer about fitting a new one, but I may get that new one from the above link.

Will see if I can sell my broken one to someone to refurb and resell it on.

On the upside, the house we stayed at was great and produced some lovely pics of the car outside, before the incident.







AFTER:





Edited by stimshady on Sunday 29th September 18:30

tonyhall38

4,194 posts

246 months

Sunday 29th September 2013
quotequote all
You should goggle carbon fibre repair , I think you will be surprised at the cost.....if you do wanna sell it , I may take it....if the price is right..

mikey k

13,074 posts

246 months

Sunday 29th September 2013
quotequote all
Bugger frown

Little Donkey

1,544 posts

171 months

Sunday 29th September 2013
quotequote all
furious what a st!!!! Just one of those pains in the arse you can just do without. Hope you get it sorted.

hornbaek

3,832 posts

265 months

Sunday 29th September 2013
quotequote all
Sorry to hear about this. I'm doing a lot of sailing so I'm bit of an expert regarding smashing up carbon bits. As it is not a structural part you can obviously cut it out and patch it up but you will not be able to match the weave underneath the clear coat so it will not come out very nicely. Do not run your fingers across the damaged section. You risk getting some very small carbon bits into your skin and it will not come out. I think the only way is a completely new part.

stimshady

Original Poster:

1,323 posts

217 months

Sunday 29th September 2013
quotequote all
OK, thanks for the advice Christian. Will speak with dealer first thing tomorrow.

I will be much more careful going forward!!!

J12MOC

802 posts

174 months

Sunday 29th September 2013
quotequote all
Sympathy from me! It's really low and I've had a couple of will it wont it clear on speed bumps. Hope you get it fixed...weren't there some Chinese carbon parts on here recently?eek

erics

2,720 posts

241 months

Sunday 29th September 2013
quotequote all
Wow Matt, this is seriously painfull.

Mind you there are far worse things in life.

I would take time to find the best deal. Am sure there are plenty of options. Even a plastic one for London may not be a bad idea.

Edited by erics on Monday 30th September 12:53

JohnG1

3,487 posts

235 months

Monday 30th September 2013
quotequote all
I killed one of these a couple of years back. GBP4000 for the part and fitting at Works Service.

May I respectfully suggest that you are careful about how you dispose of this part after replacement? Happy to discuss further offline.

Omaruk

734 posts

189 months

Thursday 17th October 2013
quotequote all
The topiary at the house is great! Where are the bonnet vents or is it the light?