Change Display Language and Fault Message in the DISPLAY

[Tom The Cat]

Hello and good moring gentleman,

question ...
how to change the language on the display? (DB9 2008)
What are the steps that needs to do in order to change the language?
1. ...
2. ...
etc.

I have a Workshop-Manual from the DB9 , but only from 2005 to 2007 , i guess!
If somebody wants it to have ... no problem!
But maybe somebody of you Gents, have one form 2008 - 2010 ... would be great to get it ...

Fault in the DIM:

->I saw, that a Message appears in the right display, the message Tire Pressure Fault (indicator or transducer), sorry, I can not remember exactly how the message said.
The message text was I think, red.

the owner said that the workshop make only a reset () and the message would be gone! What do you think?

Is it probably a transducer or Tirepressuresensor error or control unit ECU
What can i do?
Have you, such a message had before?
What was next?

Thanks in advance for your answers
TTC

[petop]

Tyre Pressure fault could be the box under the passenger footwell (thats where it is in the Vantage so not sure in a DB9). If its there have a look and see if any lights are lit/flashing. If its not the box then it could be the valve transducers themselves. Check to to see if tyres have been replaced lately.

[Neil1300r]

Depends on the message re tyre pressure. Not sure why everyone assumes when they get a message it must be a sensor at fault. When I've had it I had a puncture / under inflated tyre.

[SS972]

Hello Tom,

to change the language in the DIM and infotainement it must be done via the AM dignostic equipement.
So main dealer only unless you have access to an AMDS.

[Tom The Cat]

SS972 said:

Hello Tom,

to change the language in the DIM and infotainement it must be done via the AM dignostic equipement.
So main dealer only unless you have access to an AMDS.

Hello SS972

Ok thank you!
AMDS --> No,I don't ... is there somthing usefull to buy ..fleebay ...etc?

thanks Tom