Changing the Brake Pressure Transducer
Changing the Brake Pressure Transducer
Author
Discussion

sundayjumper

Original Poster:

531 posts

313 months

Tuesday 28th November 2017
quotequote all
My car gave me the ever-popular "Emergency Brake Assist Failure" message at the weekend after sitting unused for a fortnight and being a bit sluggish to start. I've goggled and understand that TADTS when the battery's a bit low, but is it *just* due to the battery or is it an early warning that the transducer really is on the way out ? I'll probably replace it anyway I'm just wondering how urgent it is.

Also, based on its location, I'm expecting brake fluid to come pouring out when you remove the old one. Is that right ?


davek_964

11,377 posts

206 months

Tuesday 28th November 2017
quotequote all
If I remember correctly, when I did mine I only lost a small amount of fluid. I just stuck a container underneath it (although I seem to remember there wasn't much space) and swapped the part.

Note that for me, it didn't solve the problem. Mine turned out to be the brake pedal travel sensor.

bogie

17,108 posts

303 months

Tuesday 28th November 2017
quotequote all
I did mine and barely lost any, just a dribble, it was easy 10 min job, so long as you have the right tool selected for easy access beforehand

sundayjumper

Original Poster:

531 posts

313 months

Tuesday 28th November 2017
quotequote all
davek_964 said:
Note that for me, it didn't solve the problem. Mine turned out to be the brake pedal travel sensor.
Great ! Will add that to the list. Is it an easily available Ford/Jag/Volvo part ?


davek_964

11,377 posts

206 months

Tuesday 28th November 2017
quotequote all
sundayjumper said:
Great ! Will add that to the list. Is it an easily available Ford/Jag/Volvo part ?
That I don't know. After I tried the transducer and it didn't solve the problem, I took it to my Indy to read the codes and they identified the fault and booked it in to replace the part. I assume they used the Aston part and from memory parts and labour were slightly over £200 Inc.

bogie

17,108 posts

303 months

Tuesday 28th November 2017
quotequote all
Out of the 2 sensors, the transducer looked the easiest to change, so I did that first and got lucky

sundayjumper

Original Poster:

531 posts

313 months

Tuesday 28th November 2017
quotequote all
I'm not going to stake my reputation on it, but it seems to be an ATE part that's used on loads of cars that have an ATE servo. I *think* it's one of these:

https://www.ebay.co.uk/itm/131896697725

The one in my car at the moment is the same as this:



10.6318-9077.1 but Googling that part number only comes up with s/h items. The part no. must have been superseded.



Edited by sundayjumper on Tuesday 28th November 21:21

sundayjumper

Original Poster:

531 posts

313 months

Thursday 21st December 2017
quotequote all
Minor update. I kept ignoring the "Emergency Brake Assist Failure" message but it became more regular. Then it was joined by a tyre pressure warning. Which I also ignored, of course, assuming TADTS. It went away after a few miles on the motorway so I figured it was just being finicky about the cold weather.

Eventually I checked the tyre pressures and the osf was about 10psi down redface

Having inflated it to the correct pressure the brake error has not returned ! So maybe a difference in tyre pressures can trick the car into thinking there's an ABS problem ?