DB9 Rear Cabin Lights
Discussion
I've just tried to replace one of the rear cabin lights on the pillar. The lens came off fine, but there was a fitting behind this into which the lamp holder fitted. This has fallen down inside the pillar. Any ideas how to retrieve and before I "do" the other side, is there a method to avoid losing the fitting?
I had the same experience. There's a metal bracket that I think is meant to position the lamp properly. I ignored it and was able to re-position the lamp without it.
During another project I removed many rear interior panels and finally found the errant bracket. It's a huge job to get it back, so if you don't need it (and it doesn't rattle), just assume it's lost forever.
During another project I removed many rear interior panels and finally found the errant bracket. It's a huge job to get it back, so if you don't need it (and it doesn't rattle), just assume it's lost forever.
I did the same on my 2007 DB9 and had the same issue, the metal bracket dropped behind the trim panel and I was left holding just the plastic light. However I found just slipping the lamp holder clicked back together into the trim hole was perfectly fine. It's a nice tight fit so they don't move or wiggle about and the lack of the metal bracket made no discernible difference.
Gassing Station | Aston Martin | Top of Page | What's New | My Stuff


