Parcel Shelf Dropping
Parcel Shelf Dropping
Author
Discussion

samastonlongley

Original Poster:

171 posts

121 months

Sunday 28th January 2018
quotequote all
So I have a 2006 Aston Martin Vantage and it’s great aside from a few niggles, one of which is the forever dropping parcel shelf... after every journey I find it slumped in the boot held in only by the two balls at the back of the boot. Having seen the prices of the parcel shelves I’m trying to avoid buying a new one and instead trying to find a way to stop it happening or to repair the problem! Has anyone else experienced this? I know a lot of people have wrote about the squeaky noises the parcel shelf makes but no one seems to write about them falling out. Any help would be greatly appreciated!

bogie

17,108 posts

303 months

Sunday 28th January 2018
quotequote all
Simple question, but has it not got the two string supports at the sides of the boot lid hooked on ? I cant imagine how it can fall out with these in place. There are the two balls you mention and the slot at the rear then 2 side supports that hook either side to the boot hatch lid

samastonlongley

Original Poster:

171 posts

121 months

Sunday 28th January 2018
quotequote all
bogie said:
Simple question, but has it not got the two string supports at the sides of the boot lid hooked on ? I cant imagine how it can fall out with these in place. There are the two balls you mention and the slot at the rear then 2 side supports that hook either side to the boot hatch lid
Yes the two strings are attached but it drops at the point where the two pins are on either side that clip into the side of the boot door card..

samastonlongley

Original Poster:

171 posts

121 months

Sunday 28th January 2018
quotequote all


This is how I find it after most trips.

divetheworld

2,565 posts

166 months

Sunday 28th January 2018
quotequote all
The plastic pins that engage in the slots in the body bend and then become useless. Its because the plastic parts are fixed into what is essentially a fibre board. The board gives at the fixing point and eventually and the loses rigidity.
Take the shelf out and straighten the pins to the correct position. Then inject loads of epoxy adhesive into the shelf through the hole the pins project from.
The adhesive will fill the cavity and bond the fixing to the fibre board and strengthen the fibre board like a composite. This has lasted years for me.
Don't get the adhesive everywhere so do be careful.