DB9.2 coupe interior trim removal to find a buzz
Discussion
Hello folks,
I have a niggling buzz coming somewhere around the area back from the passenger door. I think it is coming from behind the roof lining or near the rear interior light. It only happens when on rough road surfaces at lowish speed.
Before I start thinking about pulling bits of trim off:
- are there any cables or wires running between the roof lining and the shell in that area, towards where the side windows are?
- does anyone have experience of removing these pieces of trim, are they push fittings?
- any schematics?
- is this similar to something someone has had before and cured?
Thanks in advance for any tips and advice.
I have a niggling buzz coming somewhere around the area back from the passenger door. I think it is coming from behind the roof lining or near the rear interior light. It only happens when on rough road surfaces at lowish speed.
Before I start thinking about pulling bits of trim off:
- are there any cables or wires running between the roof lining and the shell in that area, towards where the side windows are?
- does anyone have experience of removing these pieces of trim, are they push fittings?
- any schematics?
- is this similar to something someone has had before and cured?
Thanks in advance for any tips and advice.
Rappa said:
Thanks for posting this sean. I found the same video earlier when I started googling, so that does answer my question horray! I think the culprit may well be the rearmost fir tree clip as there is some movement between the roof lining and the cant rail causing a little squeek/rubbing. I think I will ask AM to sort it, I dont feel confident pulling the trim off like he did, even though it could be a simple job.I thought I would give an update on this.
I noticed that the far rear section if the headliner on the passenger side had a little bit of play in it and squeaked when pushed, I presumed the fixing in that corner was not right.
After much youtube homework and some good wine I decided to give the trim removal a go.
First thing was to order the fir trees which are used to hold the various bits of trim in place. I ordered a pack of 20 of the two sizes from Nicholas Mee. I did consider getting generic ones on ebay but thought the better of it just in case the fit wasnt quite right, which could lead to further rattles and buzzes. Took a full week for the package to arrive, which was today.
I wanted to avoid pulling the inside apart so I focused on the corner in question. The first fir tree at the back of the cant rail was a right b
d to get out, my word they like a fight. Its not helped by the contortions required to access to space. Once out it took some patience and brute force to get the cant rail loose to then attack the headliner. Again, the rearmost fir tree didnt want to come out, however it was soon clear that this little f
ker was a failed piece as it wouldn’t sit tight against the panel. Once out it was evident that the firs had been damaged or squashed in a previous owners life. My hopes were high, culprit found. Managed to get the replacement trees in place and everything went back together without much drama.
The obligatory road test followed, followed swiftly by a lot of cursing, I had failed to remove the buzz, back to the drawingboard.
Back home I started prodding the cant rail about and by accident found that the buzz was coming from the very thin rubber seal where the rail meets the top of the rear window. The rubber was a bit stiff and crackled as I pushed along it with my finger. A bit more pushing and rubbing and the cracking stopped. Went out of another road test and the buzz was very feint or gone most of the time. A tiny bit of silicone spray carefully administered at some point will have the rubber softened and the noise completely gone.
So although it was a waste of time taking the trim apart I did fix the problem by other means, and got to know my car a bit more, which I am rather enjoying.
I noticed that the far rear section if the headliner on the passenger side had a little bit of play in it and squeaked when pushed, I presumed the fixing in that corner was not right.
After much youtube homework and some good wine I decided to give the trim removal a go.
First thing was to order the fir trees which are used to hold the various bits of trim in place. I ordered a pack of 20 of the two sizes from Nicholas Mee. I did consider getting generic ones on ebay but thought the better of it just in case the fit wasnt quite right, which could lead to further rattles and buzzes. Took a full week for the package to arrive, which was today.
I wanted to avoid pulling the inside apart so I focused on the corner in question. The first fir tree at the back of the cant rail was a right b
d to get out, my word they like a fight. Its not helped by the contortions required to access to space. Once out it took some patience and brute force to get the cant rail loose to then attack the headliner. Again, the rearmost fir tree didnt want to come out, however it was soon clear that this little f
ker was a failed piece as it wouldn’t sit tight against the panel. Once out it was evident that the firs had been damaged or squashed in a previous owners life. My hopes were high, culprit found. Managed to get the replacement trees in place and everything went back together without much drama.The obligatory road test followed, followed swiftly by a lot of cursing, I had failed to remove the buzz, back to the drawingboard.
Back home I started prodding the cant rail about and by accident found that the buzz was coming from the very thin rubber seal where the rail meets the top of the rear window. The rubber was a bit stiff and crackled as I pushed along it with my finger. A bit more pushing and rubbing and the cracking stopped. Went out of another road test and the buzz was very feint or gone most of the time. A tiny bit of silicone spray carefully administered at some point will have the rubber softened and the noise completely gone.
So although it was a waste of time taking the trim apart I did fix the problem by other means, and got to know my car a bit more, which I am rather enjoying.
Gassing Station | Aston Martin | Top of Page | What's New | My Stuff


