ASM Driving Technique
ASM Driving Technique
Author
Discussion

rocketboots999

Original Poster:

26 posts

109 months

Sunday 1st April 2018
quotequote all
I have a question for Vantage ASM owners. I got my car late last year, so with the new driving season just starting I am still getting used to it. I purposely chose an ASM car although my classic cars have always been stick.

Sport mode selected. Going up through the gears, I use the toe roll/foot lift trick and it works fine for steady driving, although there is a bit of a lag going 1st to 2nd.

When I accel quite hard in first from a stop and try to shift into 2nd, the car goes into neutral, revs higher and I have to let the revs come back down before the paddle finally selects a gear. That loses all of the momentum that I have. I am guessing that it is a technique issue. Thoughts please?

F1 NDW

1,116 posts

177 months

Sunday 1st April 2018
quotequote all
Rocketboots as an original Vanquish owner (the first Aston to have the paddle shift manual box) what is happening with your car does not sound right at all. My owners manual tells me to keep my foot planted and just shift gears with the paddle. The car sorts the rest out itself which indeed it does. Never had it go into neutral that's for sure.

Edited by F1 NDW on Sunday 1st April 04:25

ALDV

40 posts

115 months

Sunday 1st April 2018
quotequote all
Hi...not sure I can answer but you may want to give a little more information for Members to help..
Mileage...year of car...
On ASM any Aston dealer can tell you how much clutch is left or bad. I am guessing you had this done?

If not..I would have it checked as sounds like clutch is not grabbing...

My ASM is an 09 and I never use comfort...d only in stop and go heavy traffic.

I try to upshift with the paddles but only downshift to 2nd as the car downshifts into 1st better.

Reverse is a horrible gear but needed...lol
R to 1 is not bad on my car...which once again makes me wonder if clutch is going bad.

Good luck...

rocketboots999

Original Poster:

26 posts

109 months

Sunday 1st April 2018
quotequote all
ALDV said:
Hi...not sure I can answer but you may want to give a little more information for Members to help..
Mileage...year of car...
You're right. I'm used to having the car details show in my signature on forums.

2010 V8 Vantage Roadster. 15,000 miles. Clutch is probably getting up there, but no signs of slippage on either full throttle or normal driving. I only drive Sport mode, never use D or Comfort except to show someone how bad those 2 modes are.

As well as the high rev shift issue described, I have had a couple of other instances where I have been stopped at a light with neutral selected and then it wouldn't go into gear with the paddle. Wait a few seconds, try again and the gear selects - very embarassing. I put this down to my newness with the car and some type of "driver learning curve" issue; now I am not so sure.

The service history shows that the transmission control module was replaced last year, so perhaps there is more to this than the driver...

South tdf

1,830 posts

226 months

Sunday 1st April 2018
quotequote all
I have a similar car and always drive in Sport using the paddles. I have never once had the car change into neutral without pulling both paddles whilst stopping so I would get it checked out.

I recall that if you are pressing on under full acceleration the car will “Hypershift”? Between gears when the up paddle is selected.

DB9VolanteDriver

2,661 posts

207 months

Sunday 1st April 2018
quotequote all
F1 NDW said:
Rocketboots as an original Vanquish owner (the first Aston to have the paddle shift manual box) what is happening with your car does not sound right at all. My owners manual tells me to keep my foot planted and just shift gears with the paddle. The car sorts the rest out itself which indeed it does. Never had it go into neutral that's for sure.

Edited by F1 NDW on Sunday 1st April 04:25
+1

rocketboots999

Original Poster:

26 posts

109 months

Friday 6th April 2018
quotequote all
Thanks everyone. I had a good chat with an AM Service Manager who also doubts that it is clutch wear due to it only happening during higher rev changes from 1st to 2nd and no signs of slippage. I am arranging for him to take a look at it and will report back with what they find.

Manwhoneverwas

598 posts

162 months

Saturday 7th April 2018
quotequote all
I had my V8 Roadster for 4 years before replacing the OEM clutch with a new twin plate clutch and lightweight flywheel.
This makes a big difference and I would highly recommend it.
The single plate OEM clutch was a cost cutting exercise by AM and replacing it with the twin plate (which is fitted to V12S) is the way to go.

rocketboots999

Original Poster:

26 posts

109 months

Tuesday 10th April 2018
quotequote all
Weather crappy, so haven't driven the car in a while, but hope to tomorrow to establish a few more troubleshooting data points. The car will be going to AM, but as an ex-aircraft troubleshooter on Boeing and Airbus, I like to have an understanding myself.

Today I plugged in my Foxwell with the AM code reading capability. There are a number of live data points that can be read. A couple of examples, but more available:
- Self tuned clutch closed position
- Self tuned clutch closed position - kiss point delta
- Clutch wear index

Without knowing how to decipher the data, these are about as useful to me as one hand clapping. Does anyone know which of these data points are useful for troubleshooting purposes as well as giving a sense of what is happening with the clutch and transmission?

Thanks
______________
2010 Vantage V8 Roadster

rocketboots999

Original Poster:

26 posts

109 months

Thursday 17th May 2018
quotequote all
Update re. the shift issues that I described at the start of this thread. I got the car back today from Tony and his team at Aston Martin Summit in NJ. They found that the ASM clutch fluid reservoir was low due to hydraulic hoses with slow leaks; nothing visible on the ground. Hoses replaced, under warranty, and the gear shifting noticeably improved, but still wasn't quite right. They did a test drive data dump for the AM regional troubleshooter and the consensus was that to get the car back to spec would also require a clutch change. 15.5K miles on the car, so this was not a surprise to me. The clutch friction plate wasn't quite down to the rivets, but the flywheel was badly marked up.

I spent a lot of time researching OEM vs twin-plate and understand the pro's and con's. As I have another 18 months of AM warranty and will have 12 months of clutch warranty, I elected to play it safe and go OEM this time.

The car finally, in my ownership, drives as it should, so I can now hopefully enjoy it for the Summer.

For the US readers, I have to say that I have been very pleased with the levels of service provided by Tony and his team.