Carbon light insert repair / removal / refitting
Discussion
Hello,
I noticed last time I used my car that the outer edge of the carbon light insert (08 / V8V), has some small chips in the lacquer.
I assume this is because the fit is slightly out and is allowing movement at high speed; so is there an AM process for removal and refitting, it looks like they are just stuck down? Which I want to do before the thing comes flying off!
Secondly, has anyone attempted to refinish the lacquer? I am only talking about a very small area (perhaps three 4x4 mm chips). Last time the car was in at AM they quoted £500+ for a new insert and then advised me to look at getting it refinished.
I noticed last time I used my car that the outer edge of the carbon light insert (08 / V8V), has some small chips in the lacquer.
I assume this is because the fit is slightly out and is allowing movement at high speed; so is there an AM process for removal and refitting, it looks like they are just stuck down? Which I want to do before the thing comes flying off!
Secondly, has anyone attempted to refinish the lacquer? I am only talking about a very small area (perhaps three 4x4 mm chips). Last time the car was in at AM they quoted £500+ for a new insert and then advised me to look at getting it refinished.
I can’t speak for carbon, as it’s obviously much stiffer so slightly different to remove. But it’s essentially glued and has 2 spring clips, one near either end. Get some plastic trim removal tools and gently prise it off, I did a plastic one yesterday whilst swapping out a duff rear light. It’s pretty easy. I’d assume any decent body shop could re laquer it for you. Or dare I suggest rattle cans?!
It’s come away from the light right at the curved ‘thin’ end so I am wondering if it hasn’t been reinstalled properly.
You don’t happen to have a manual / pdf do you?
Conscious I don’t want any spring clips to go ‘missing’ ...
I’m happy to (try) and rattle can it, but will do a test piece first!
You don’t happen to have a manual / pdf do you?
Conscious I don’t want any spring clips to go ‘missing’ ...
I’m happy to (try) and rattle can it, but will do a test piece first!
Lord.Vader said:
I assume this is because the fit is slightly out and is allowing movement at high speed; so is there an AM process for removal and refitting, it looks like they are just stuck down?
Watch the first few minutes of this for removal, and the last few minutes for refitting:https://www.youtube.com/watch?v=-GNUgU7xT9s
Gassing Station | Aston Martin | Top of Page | What's New | My Stuff


