Exhaust replacement - DIY?
Discussion
I've bought an AM sports exhaust for my 2010 V8V Roadster - has anyone changed the back box on their car themselves? I'm assuming it's straightforward, but thought I'd check on here first - I'd just have it on axle stands, so not that much clearance if it's awkward. If it's going to be a pain I'll just get the garage to do it!
Yep, pretty straight forward, probably a two spanner job on the haynes scale. However, the standard box is very very heavy, so have someone with you under the car to help get it out. Also a pair of circlip pliers is great to open up the exhaust clamps, and make sure the spring bolts are seated properly when putting it back in. Dont try and get the rubbers off on the car, just unbolt them if you can, then some brake cleaner sprayed on the slide them off. Job jobbed. PM my if you have any questions.
Gingernuts said:
Yep, pretty straight forward, probably a two spanner job on the haynes scale. However, the standard box is very very heavy, so have someone with you under the car to help get it out. Also a pair of circlip pliers is great to open up the exhaust clamps, and make sure the spring bolts are seated properly when putting it back in. Dont try and get the rubbers off on the car, just unbolt them if you can, then some brake cleaner sprayed on the slide them off. Job jobbed. PM my if you have any questions.
Great - thanks very much for this. Is it best to remove the rear diffuser, and would you take the tailpipe finishers off before dropping the exhaust?I did this myself and mirror some of the comments above, the OEM exhaust is app. 25Kg, therefore, when you remove it, make sure it is properly supported. Sometimes using a jack and rubber pad/piece of wood underneath is enough just to hold it and gently lower.
Some of the bolts between the pipes and back box are a bit of a pain to get too, but nothing a little WD40, wrench and some extenders wont sort. It is generally nuts and bolts, so not a difficult job.
I didn't remove the diffuser or tail pipe finishers. However, if you find that it makes access easier, then why not.
Make sure you get some exhaust paste/gum and use it on any of the joints to aid sealing when fitting the new exhaust.
Some of the bolts between the pipes and back box are a bit of a pain to get too, but nothing a little WD40, wrench and some extenders wont sort. It is generally nuts and bolts, so not a difficult job.
I didn't remove the diffuser or tail pipe finishers. However, if you find that it makes access easier, then why not.
Make sure you get some exhaust paste/gum and use it on any of the joints to aid sealing when fitting the new exhaust.
Gassing Station | Aston Martin | Top of Page | What's New | My Stuff


