New owner niggles question
New owner niggles question
Author
Discussion

JB65

Original Poster:

146 posts

103 months

Sunday 6th May 2018
quotequote all
I have been driving my “new” 2011 V8S for a week now - taking it on a 2000 km roadtrip. Very pleased with the the car. Car bought from AM dealership with year warranty so want to make sure I catch all oddities.

3 Things so far

- After washing the car found damp in rear lights
- breaks squeek at low speed
- soft knocking sound while driving at bad roads, assuming rear springs

Seems like things that should be fixed/fixable but appreciate your feedback
Thanks!

telum01

987 posts

146 months

Sunday 6th May 2018
quotequote all
These are common:
- After washing the car found damp in rear lights
- breaks squeek at low speed

The condensation in your tail lamps is something you'll want to remedy before it ruins the lamps. Factory-recommended solution is to drill a hole in the housing and blow air into the lamp to get the water out.

Brake squeal is caused by a few things:
1) Pads need to be bedded in
2) Need anti-squeal grease on the backing plates (the factory offers shims that can help).
3) Front pads aren't chamfered, so material can get built up on their leading edges, which causes squeal.

Tons of documentation on all of this if you search around a bit.

The rear suspension could be a few things. Might be the struts are worn out or are wearing out (look for signs of leaking). Control arm bushings may be another thing to look at.

PatCub

250 posts

147 months

Monday 7th May 2018
quotequote all
The reason the rear lights leak is because of the poor seal between the two halves, the seal is a piece of double sided tape.
Heat the lens in the oven at a low temp. Pull the two halfs apart, dry lens out, remove the black double sided tape and reseal with a silicone sealer.


anonymous-user

85 months

Monday 7th May 2018
quotequote all
Mine still squeak, although my car does stand for 3-6 months at a time.

The only time it stopped was after I used it consistently for a few weeks.

Always a different wheel / brake squeaking too.

Lesson = drive it a lot and quickly.

JB65

Original Poster:

146 posts

103 months

Monday 7th May 2018
quotequote all
Thanks for the help. Had another good listening session and sound from the rear springs is more a squeaky sound rather than a knock that synchronises with the bumps in the road. Maybe just spring lubrication? Any additional thoughts appreciated!

telum01

987 posts

146 months

Monday 7th May 2018
quotequote all
Squeaking could be the control arm bushings.

V8V Pete

2,536 posts

157 months

Monday 7th May 2018
quotequote all
JB65 said:
Thanks for the help. Had another good listening session and sound from the rear springs is more a squeaky sound rather than a knock that synchronises with the bumps in the road. Maybe just spring lubrication? Any additional thoughts appreciated!
Is it temperature dependent? If so, it may be a deformed donut seal between the exhaust mid section and the back box. Mine did this. Main dealer said it was the exhaust valves and would need a new back box to solve. I thought BS. Bamford Rose diagnosed it as the donut and fixed it for a few pounds. Awesome smile

nickv8

1,570 posts

114 months

Tuesday 8th May 2018
quotequote all
1) Get the misted tear light unit changed under the AM warranty at no additional cost. I would only look to fix myself out of warranty (some great experience of that on here).

2) The break squeak is part of the nature of this and other similar sports cars. It’s even stated in the owner’s handbook. I use my 2014 V8V regularly (at least one good drive each week, over winter too) and the squeaking comes and goes. I’ve heard worse smile

3) I assume you’ve found the rear noise isn’t from the rear hatch? Mine squeaked over rough surfaces. Mentioned it at my last service with AM Bristol and they did some magic to fix it which was really appreciated as I live in the country and have to cross the border to Wales for smooth black top.

dbs2000

2,756 posts

223 months

Tuesday 8th May 2018
quotequote all
PatCub said:
The reason the rear lights leak is because of the poor seal between the two halves, the seal is a piece of double sided tape.
Heat the lens in the oven at a low temp. Pull the two halfs apart, dry lens out, remove the black double sided tape and reseal with a silicone sealer.

Nooooo, do not use silicone it makes one hell of a mess. My updated guide is here:

https://www.pistonheads.com/gassing/topic.asp?h=0&...

Edited by dbs2000 on Tuesday 8th May 08:16

PatCub

250 posts

147 months

Tuesday 8th May 2018
quotequote all
dbs2000 said:
Nooooo, do not use silicone it makes one hell of a mess. My updated guide is here:

https://www.pistonheads.com/gassing/topic.asp?h=0&...

Edited by dbs2000 on Tuesday 8th May 08:16
I stand corrected, thank you and well done on finding a descent sealing material.
How well does it squash in the joint?

dbs2000

2,756 posts

223 months

Tuesday 8th May 2018
quotequote all
Pretty well, it's OEM stuff. I wrote the original guide and used silicone as you previously suggested and it does do the job but I found it went everywhere.

I found this stuff by looking at the OE process and speaking to a few US tuners that customise customer lights. You need to roll it out and I found pre-heating the cover always helps. Here's a good guide:

https://www.youtube.com/watch?v=duFXYRt_nD0



Edited by dbs2000 on Tuesday 8th May 12:05