Rear Park Assist - Long Chime - V8V 06
Rear Park Assist - Long Chime - V8V 06
Author
Discussion

dopsonj

Original Poster:

315 posts

151 months

Monday 14th May 2018
quotequote all
Morning all,

Got my car back from Chichester after they replaced both wing mirrors under warranty - car was trailer to & from them from myself in East Sussex.

Went down to collect my car for the weekend on Friday from the barn storage area I keep the vehicle (you have to reverse in) and when I started it up I was greeted with a long single tone beep - not something I'd had before but nothing illuminated on the dash so I dismissed it as a reset that had been performed.

Anyway last night I took the vehicle down to Brighton, go to reverse in to a parking space (First time since collection I had to use reverse) and I was again greeted with a long single tone beep. A bit of investigation and realising the parking assist button now illuminated I fiddled around, pressing the button however was again greeted with a long beep. Getting my friend to jump out and walk around the car we concluded that no matter if the parking button starts "off" or "on" the rear sensors no longer beeped in their typical fashion and I am just presented with the one single beep.

Not much I can see in the manual, all I can conclude is that the long beep is an indication that "Be aware, this module isn't working correctly, you aren't going to get parking sensors".

I've attached a quick video, if anyone has any answers that'd be great,

Thanks

Jack

https://www.dropbox.com/s/22upzlapg47agbz/IMG_4663...


DaveV8V

89 posts

129 months

Monday 14th May 2018
quotequote all
Hi Jack,

I have had a similar problem, normally happens after I have washed the car with a pressure washer. In my case I am presuming that moisture or dirt has been forced into/around the sensor. Try blowing air across the sensors to clean it with an air-line, hair-dryer (cool), etc. to dry it out and remove any muck.

Hope that helps

D

Fullmel

146 posts

196 months

Wednesday 16th May 2018
quotequote all
The long beep is an audible warning telling you there is a fault within the park aid system.

john ryan

542 posts

163 months

Wednesday 16th May 2018
quotequote all
Standard Ford system, as found on JLR products etc. As said, system is warning you it is out of action - probably a failed or waterlogged sensor

bogie

17,107 posts

303 months

Wednesday 16th May 2018
quotequote all
Sometimes goes away when they dry out, if not then there is a procedure a dealer can do to identify which sensor(s) need replacing. They are not very expensive, its just labour cost that can bump the job up at a main dealer versus indy.

raceboy

13,940 posts

311 months

Wednesday 16th May 2018
quotequote all
If you listen to a parking sensor, the actually bit in the bumper, it will make a faint 'buzz' if it is working, mine was making the long 'bong' inside a few weeks ago, intermittently though, and obviously never when it was back at the dealers, they do seem to be quite temperamental and don't like getting wet. rolleyes

Chris.Owen

110 posts

104 months

Wednesday 16th May 2018
quotequote all
Mine does this, I think I’ve had the sensors work only once since I bought her. I get the long time as soon as I turn the ignition on, and when selecting reverse, very annoying!

steveatesh

5,385 posts

195 months

Wednesday 16th May 2018
quotequote all
I had the exact same symptom, as above it is a failed sensor.

Simply put an empty toilet roll against each sensor in turn (ignition on, reverse gear selected), out your ear to the toilet roll holder and you will hear a faint buzzing noise. The broken sensor will be silent.

Mine was about £45 to fix with an AM part, and an hours work. It is a diy repair if you have a mind too.

Oh, don’t use Izal toilet roll as it’s not befitting an Aston wink

Manwhoneverwas

598 posts

162 months

Wednesday 16th May 2018
quotequote all
I have had the exact same issue recently and my V8VR is going to the AM Indy on Friday to investigate.
There are the 4 x rear sensors (2 outer and 2 inner) and also the parking module itself.

Parking Aid Module is £114.30 + VAT Part number 9G433711061 (It is actually a Jaguar part, but is cheaper from Aston)
Sensor Parking Aid is £48.44 + VAT Part number 4G433710044
Sensor-RR-Park Anodz is £48.52 + VAT Part number 4G433710045

To change the parking aid module takes 10 minutes, but requires to be enabled using AMDS software



Chris.Owen

110 posts

104 months

Thursday 17th May 2018
quotequote all
Surely if it’s already fitted it won’t need to be enabled via the diagnostic software? A like for like swap should see it function straight away, especially seeing as it’s a Jaguar part, which doesn’t need activating when fitted to a jag.

Manwhoneverwas

598 posts

162 months

Friday 18th May 2018
quotequote all
The AM Indy used their AMDS to diagnose a faulty right (inner) sensor as being faulty.
Many thanks to Peter at Martins Aston Services