Washer jet covers
Discussion
The end portion of the washer is held with a U clip which can be seen in the photo

Get someone to activate the washers while you get ready to grab the head whilst extended, then remove the clip and it's fairly easy to swap the head, it's just a bit fiddly trying to hold the unit extended whilst fitting the new head and pushing the clip home.
I don't think the end cover is supposed to actually come off, but does seem to fall off sometimes, so when fitting the new one hold the tension via some thin nosed pliers on the male part of the tube, don't pull on the cover of the washer head if you can avoid it.
Get someone to activate the washers while you get ready to grab the head whilst extended, then remove the clip and it's fairly easy to swap the head, it's just a bit fiddly trying to hold the unit extended whilst fitting the new head and pushing the clip home.
I don't think the end cover is supposed to actually come off, but does seem to fall off sometimes, so when fitting the new one hold the tension via some thin nosed pliers on the male part of the tube, don't pull on the cover of the washer head if you can avoid it.
Thanks for the pic - it looks quite clear on what to do. Interestingly, there is a blob of black silicone holding the clip on. Also, when the cover is off, there is a ball joint receptacle visible.
Is there a hack that extends the washer out and holds it there? I know there is one for the wiper blades?
Is there a hack that extends the washer out and holds it there? I know there is one for the wiper blades?
I think the washer head is pushed forwards with water pressure when the pump is activated so I don't think there is a hack to get it to stay out.
Yes there is a ball joint connection on the end, but I don't think you can actually buy just the end piece, my replacements came as one piece units.
Oddly my old heads also had a dose of black silicone/mastic holding them together, it looked like old repair work, but I think they actually come like that new as I could see it on my replacements, it is also visible in the one on the photo which is from a general google image search.
Yes there is a ball joint connection on the end, but I don't think you can actually buy just the end piece, my replacements came as one piece units.
Oddly my old heads also had a dose of black silicone/mastic holding them together, it looked like old repair work, but I think they actually come like that new as I could see it on my replacements, it is also visible in the one on the photo which is from a general google image search.
Edited by Manx V8V on Friday 6th July 23:50
Manx V8V said:
I think the washer head is pushed forwards with water pressure when the pump is activated so I don't think there is a hack to get it to stay out.
Yes there is a ball joint connection on the end, but I don't think you can actually buy just the end piece, my replacements came as one piece units.
Oddly my old heads also had a dose of black silicone/mastic holding them together, it looked like old repair work, but I think they actually come like that new as I could see it on my replacements, it is also visible in the one on the photo which is from a general google image search.
Ambits sell just thew cover only. I reckon a bit of epoxy should hold it there forever....Yes there is a ball joint connection on the end, but I don't think you can actually buy just the end piece, my replacements came as one piece units.
Oddly my old heads also had a dose of black silicone/mastic holding them together, it looked like old repair work, but I think they actually come like that new as I could see it on my replacements, it is also visible in the one on the photo which is from a general google image search.
Edited by Manx V8V on Friday 6th July 23:50
Gassing Station | Aston Martin | Top of Page | What's New | My Stuff


