Ignition Key Starter Bezel Replacement

[Damianos]

Hi all!

Just bought these inserts to replace the old ones that have worn out on my 2009 Vantage.





I searched around a bit, but could not find any installation guides, does anyone have any clue on how to do it?

Thanks in advance,

Damien

[bignoise]

I was in same position as you and in the end I bought the complete unit

Once out I can see the individual bezels cannot be lifted and withdrawn so I would recommend that you remove the complete unit and do it at the table

[Damianos]

Thank you!

Is it easy to remove the entire unit (i'm guessing with some short of trimming tool...) ?

I'm just now starting to do some very simple DIY work on my cars as i'm not very confident with my hands, if it's something to complicated i'll probably have the dealer do it!

[Handyman2009]

yes use some plastic trim puller, there are 4 clip, if you have a GPS it is a little harder. Sorry can't tell you the step with GPS as I don't have one

Here is the bottom of mine

Edited by Handyman2009 on Thursday 10th January 11:43

[bignoise]

When I did mine with Sat Nav I just left it fitted to the panel and unplugged the 2 connectors, 1 for display and the other for the motor

[Damianos]

Thanks! Will have a go at it and see how it goes!