This reversing up a slope thing..
This reversing up a slope thing..
Author
Discussion

milu

Original Poster:

2,514 posts

297 months

Saturday 13th July 2019
quotequote all
For boring reasons I prefer to reverse my V8V into the garage.
However it is up a slight slope,around 5% I reckon
Obviously I only use light throttle and don't ever smell the clutch. Bad idea? Clutch is 15k miles old but I've only done 800 of those.

Buster73

5,627 posts

184 months

Saturday 13th July 2019
quotequote all
Anyone got a clue ?

V8V Pete

2,536 posts

157 months

Saturday 13th July 2019
quotequote all
Try using zero throttle, easing the clutch peddle up very gently and rely on the anti-stall software. Works very well and results in less slipping of the clutch so lower chance of overheating it. I think the anti-stall got better in the later cars but don't have details.

milu

Original Poster:

2,514 posts

297 months

Saturday 13th July 2019
quotequote all
I generally take a couple of bites at it whilst avoiding hitting the wall lol

Graze01

1,202 posts

123 months

Saturday 13th July 2019
quotequote all
Milu

the problem I have is that its almost impossible to fully release the clutch as the rear view is so limited (even with the camera on the new one - which i have to say I still dont trust completely)

So the tendency is to ride it or slip it (depending on the slope) and thats what does the damage

I just try & avoid it at all costs

Graeme

V8V Pete

2,536 posts

157 months

Saturday 13th July 2019
quotequote all
Obviously you can't get a manual car moving without slipping the clutch because that's how it works. The thing that really does the damage (to the friction plate) is slipping it at high revs and overheating it. Hence why using the anti-stall is a good idea. It enables you to reverse in a controlled way, at manageable speed whilst slipping the clutch at the lowest engine speed possible without stalling. Try it.

bogie

17,100 posts

303 months

Saturday 13th July 2019
quotequote all
As per Petes advice above, release clutch really slowly, then let the anti stall take over. Once you get used to it you will wonder what all the fuss was about.

From 2012 on (I think) all models have the hill hold to save you clutch slipping on hill starts. The car will hold the brake for you until you move off.

RL17

1,614 posts

124 months

Saturday 13th July 2019
quotequote all
Cameras on newer ones/parking sensors on rear plus keeping nose of car/splitter away from wall etc must make it the better solution plus

getting in car and starting up engine and driving off with no fuss/reversing manoeurvres etc must be best reason.


milu

Original Poster:

2,514 posts

297 months

Saturday 13th July 2019
quotequote all
As above. A few good reasons to back in. Plus better door opening room since I park on the right side of my garage.
I’ll try the anti stall method but to be honest I only use tick over revs anyway since it’s a gentle slope
Thanks all

johns355

544 posts

185 months

Saturday 13th July 2019
quotequote all
I’ve needed a new clutch on my last 3 cars partly due to me reversing on full lock up my inclined short drive into my garage. Didn’t realise how bad it was for my clutch until reading on here! Ever since I had the uprated clutch on my 08 V8vr 20 months ago I just drive straight in now. It doesn’t look so good when I open the garage doors but I’m sure will pay dividends on my wallet!

milu

Original Poster:

2,514 posts

297 months

Saturday 13th July 2019
quotequote all
johns355 said:
I’ve needed a new clutch on my last 3 cars partly due to me reversing on full lock up my inclined short drive into my garage. Didn’t realise how bad it was for my clutch until reading on here! Ever since I had the uprated clutch on my 08 V8vr 20 months ago I just drive straight in now. It doesn’t look so good when I open the garage doors but I’m sure will pay dividends on my wallet!
Is it steep?

Oilchange

9,727 posts

291 months

Saturday 13th July 2019
quotequote all
Would’ve thought this exercise would be a basic requirement of any car...