Window position reset?
Window position reset?
Author
Discussion

dibblecorse

Original Poster:

7,666 posts

223 months

Wednesday 4th November
quotequote all
2021 Vantage Roadster, when i close the roof and hold the button as required the drivers window closes completely but the passenger one rises an inch or so then stops, is this a window or roof calibration issue?

in all other respects all works as it should.

is there a position reset procedure?

V8 Minotaur

261 posts

26 months

Wednesday 4th November
quotequote all
Hmm that does sound a bit strange.

Is this only when using the roof switch then, and the passenger window works normally on both the door switches?

Guessing here, but I imagine a reset would be from the door switches rather than the roof switch.

Have you tried holding the passenger door switch fully down for say 5 seconds and then fully up, to see if it goes higher?

Hopefully it's not a bit of water ingress from Sunday's drive.

V8 Minotaur

261 posts

26 months

Wednesday 4th November
quotequote all
Oh, and in passing are you aware of the re-circ button feature?

May even be worth trying that to see if it helps the window move again.


dibblecorse

Original Poster:

7,666 posts

223 months

Wednesday 4th November
quotequote all
Cheers mate, and yes, issue only on the roof button, otherwise works fine, went out on a great Cotswold run today ...

Davil

780 posts

57 months

Thursday 5th November
quotequote all
The way this happens is if you are an absolute dumbass one day go into brain autopilot and press the window button instead of the roof button thinking you were pressing the roof button.

Ask me how I know. :-P

V8 Minotaur

261 posts

26 months

Thursday 5th November
quotequote all
Maximum cortisol flood thinking the roof has broken, followed by, I don't think anyone noticed rolleyes

V8 Minotaur

261 posts

26 months

Thursday 5th November
quotequote all
Well I'm sure you've tried it already but all I can think of is to lower the roof, holding the roof button up for 5 more seconds and then repeat with the push down to close action, and try that a few times.

If it works ok on both the driver and passenger side door buttons then there must be a connection to the roof button only, or a microswitch signal from the roof position.

Did you try holding the re-circ button too, to see if you get the correct operation from that?

Good luck and let us know when resolved.

V8 Minotaur

261 posts

26 months

Thursday 5th November
quotequote all
Oh, and be sure to have the engine running. wink

EVR

2,259 posts

91 months

Thursday 5th November
quotequote all
Just out of sheer curiosity, where is the roof button located on the Roadster?

V8 Minotaur

261 posts

26 months

Thursday 5th November
quotequote all
Driver's door, just behind the window and boot buttons.



Edited by V8 Minotaur on Thursday 5th November 11:35


Edited by V8 Minotaur on Thursday 5th November 11:35

EVR

2,259 posts

91 months

Thursday 5th November
quotequote all
Intelligent placing. Thanks.

dibblecorse

Original Poster:

7,666 posts

223 months

Thursday 5th November
quotequote all
Cheers all, will try all those tomorrrow, if no joy will just pop into AM Reading as they are just up the road and ask a tech ....

V8 Minotaur

261 posts

26 months

Friday 6th November
quotequote all
Any excuse for a drive eh. wink

dibblecorse

Original Poster:

7,666 posts

223 months

Friday 6th November
quotequote all
V8 Minotaur said:
Any excuse for a drive eh. wink
Just back from Podium lol ..... was quite mild, roof off, hat on, tunes ......

Window update, after some various window up, window down, button holding and crossing of fingers I have no idea what worked but something did so normal service has been resumed ...... lol


Davil

780 posts

57 months

Saturday 7th November
quotequote all
dibblecorse said:
Just back from Podium lol ..... was quite mild, roof off, hat on, tunes ......

Window update, after some various window up, window down, button holding and crossing of fingers I have no idea what worked but something did so normal service has been resumed ...... lol
That’s pretty much how I fixed mine. Or did it fix itself? Who knows.