Looking to buy an e36 328, what to look out for?
Discussion
so now i'm 21, i'm looking for an e36 328. are there any common things to look out for???
so far things i have researched:
vanos rattle
rust/rot on sills and archs
headgasket failure
overheating caused by borked water pump and thermostat.
are there any other common issues to keep an eye out for?
so far things i have researched:
vanos rattle
rust/rot on sills and archs
headgasket failure
overheating caused by borked water pump and thermostat.
are there any other common issues to keep an eye out for?
No youve covered it, remember these are old cars now, try to get one with history, not some snotter thats had nothing done to it, check it drives and pulls up straight, 4 wheel aleignment is expensive, i found stupidly wide /large wheels didnt suit them, i found keeping the front tyre to 205/215 improved the steering feel, make sure it aint been slammed to withing an inch of its life, try to get a sunroof, check carefully around the windscreen for rust, if its got some walk away thats what killed mine, it had 222000 on it and ran perfect.
Alot of good upgrades availible as well, manifold conversion, m3 exhaust (more fore noise, cheaper than aftermarket ones) z3 rack, z3 gearstick, e30 lower arms, to name a few, i found them to be an old school drive, quite heavy compared to the 330 that replaced it, but loads and loads of fun, a clean one will do 300000 mile, epic car.
Alot of good upgrades availible as well, manifold conversion, m3 exhaust (more fore noise, cheaper than aftermarket ones) z3 rack, z3 gearstick, e30 lower arms, to name a few, i found them to be an old school drive, quite heavy compared to the 330 that replaced it, but loads and loads of fun, a clean one will do 300000 mile, epic car.
Ahh cool. just been lurking on ebay and such like. I hate the e46 wheels the most have put on which means they are over tyred/wheeled, and will be putting some oem 16's on if it doesn't already have them.
Like you say, lots of zero history some how, and finding a one that isn't a complete nail may be hard. saying that i may be restricting myself as i have a max budget of £1k really (i don't want to spend too much on a car i'm going to crash into a hedge).
I will only be doing light mods:
m50 mani
lowering springs - 30 to 40mm
possibly a lower ratio 325 or 320 diff - may try and build a lsd into a 320 or 325 diff casing.
Modified hubs for extra steering lock like this (http://a3.sphotos.ak.fbcdn.net/hphotos-ak-ash4/400116_10150431308811697_506356696_8973062_214928964_n.jpg). which will effectively quicken the rack.
'maybe' just maybe a hydro.
oh yeh a tow hitch for the bike rack
Like you say, lots of zero history some how, and finding a one that isn't a complete nail may be hard. saying that i may be restricting myself as i have a max budget of £1k really (i don't want to spend too much on a car i'm going to crash into a hedge).
I will only be doing light mods:
m50 mani
lowering springs - 30 to 40mm
possibly a lower ratio 325 or 320 diff - may try and build a lsd into a 320 or 325 diff casing.
Modified hubs for extra steering lock like this (http://a3.sphotos.ak.fbcdn.net/hphotos-ak-ash4/400116_10150431308811697_506356696_8973062_214928964_n.jpg). which will effectively quicken the rack.
'maybe' just maybe a hydro.
oh yeh a tow hitch for the bike rack

Edited by orangesrule on Monday 7th May 11:11
orangesrule said:
Ahh cool. just been lurking on ebay and such like. I hate the e46 wheels the most have put on which means they are over tyred/wheeled, and will be putting some oem 16's on if it doesn't already have them.
Like you say, lots of zero history some how, and finding a one that isn't a complete nail may be hard. saying that i may be restricting myself as i have a max budget of £1k really (i don't want to spend too much on a car i'm going to crash into a hedge).
I will only be doing light mods:
m50 mani
lowering springs - 30 to 40mm
possibly a lower ratio 325 or 320 diff - may try and build a lsd into a 320 or 325 diff casing.
Modified hubs for extra steering lock like this (http://a3.sphotos.ak.fbcdn.net/hphotos-ak-ash4/400116_10150431308811697_506356696_8973062_214928964_n.jpg). which will effectively quicken the rack.
'maybe' just maybe a hydro.
oh yeh a tow hitch for the bike rack
Bear in mind an E36 320 uses the small case diff - 325 and 328 use the medium case one and you could use the 3.15 ratio from a 325/3.0 M3 to give you more acceleration. 328 auto uses a 3.07 which will give a halfway house between a manual 328 and the 3.15 ratio - nice with a LSD fitted Like you say, lots of zero history some how, and finding a one that isn't a complete nail may be hard. saying that i may be restricting myself as i have a max budget of £1k really (i don't want to spend too much on a car i'm going to crash into a hedge).
I will only be doing light mods:
m50 mani
lowering springs - 30 to 40mm
possibly a lower ratio 325 or 320 diff - may try and build a lsd into a 320 or 325 diff casing.
Modified hubs for extra steering lock like this (http://a3.sphotos.ak.fbcdn.net/hphotos-ak-ash4/400116_10150431308811697_506356696_8973062_214928964_n.jpg). which will effectively quicken the rack.
'maybe' just maybe a hydro.
oh yeh a tow hitch for the bike rack

Edited by orangesrule on Monday 7th May 11:11
Look around on Ebay and you'll probably find a complete diff quite cheap orangesrule said:
are there any common things to look out for???
Front suspension bushes and ball jointsMetal brake pipes (especially at the rear)
Rust everywhere (front inner wings, and around tail lights in particular) - although sills/arches are the favourite
Heater blower speeds often fail but it's an easy fix with the 'hedgehog'.
Brake light switches (easy fix)
Rear trailing arm bushes
Rear springs corrode and snap, usually at top or bottom
Rear top mounts wear quickly due to design
Climate control panels can start to play up. Usually a capacitor that needs replacing. A few people on the internet can fix them cheaply.
Wiper linkage can wear. The spindle can start moving up and down causing the wiper edge to hit the bonnet. Needs a good second hand linkage.
Rear trailing arm bushes
Rear springs corrode and snap, usually at top or bottom
Rear top mounts wear quickly due to design
Climate control panels can start to play up. Usually a capacitor that needs replacing. A few people on the internet can fix them cheaply.
Wiper linkage can wear. The spindle can start moving up and down causing the wiper edge to hit the bonnet. Needs a good second hand linkage.
Gassing Station | BMW General | Top of Page | What's New | My Stuff


