Subframe reinforcement on 330 track car
Discussion
Hi guys,
I recently purchased a 330ci from December 2001 which I intend to build into a drift car. Will have a welded diff and see a lot of track abuse..
Therefore I am wondering if this car would have the reinforced subframe that I believe BMW introduced? Any advice welcomed as there is a LOT of conflicting info on the web about which models this effects and to what odds its likely to become a problem.
If not how likely am I to experience the subframe tearing through the floor and failing?
Are there any other options apart from the turner motorsport kits?
As the car was cheap (ebay bargain) Im not really keen on spending loads on the kit+labour, but at the same time I'd rather the back of the car didnt snap in half
I am thinking of dropping the subframe and if it all looks good for now changing for some solid bushes on the diff/subframe, as from what I've read this would reduce a lot of the flex that causes the tearing in the floors.
I recently purchased a 330ci from December 2001 which I intend to build into a drift car. Will have a welded diff and see a lot of track abuse..
Therefore I am wondering if this car would have the reinforced subframe that I believe BMW introduced? Any advice welcomed as there is a LOT of conflicting info on the web about which models this effects and to what odds its likely to become a problem.
If not how likely am I to experience the subframe tearing through the floor and failing?
Are there any other options apart from the turner motorsport kits?
As the car was cheap (ebay bargain) Im not really keen on spending loads on the kit+labour, but at the same time I'd rather the back of the car didnt snap in half

I am thinking of dropping the subframe and if it all looks good for now changing for some solid bushes on the diff/subframe, as from what I've read this would reduce a lot of the flex that causes the tearing in the floors.
It is simple enough to drop the subframe out especially if you are going to remove the diff anyway.I did not buy a reinforcing kit as I thought £150 for £10 worth of 16 gauge was taking the mickey. You can easily see where the floor needs plating and make card templates to suit. I used a spot-weld cutter drillbit to make a hole in the outer skin and then welded the two layers together before adding the plating. Be sure to put two spacers of your plating metal under the alloy bracket near the front of the diff or it may crack when the bolts are tightened.The trickiest part is removing the old rubber mountings, I would use a large drill, then fit powerflex or solid bushings as the OEM bushes need two special tools buying, borrowing or making to install them.
Gassing Station | BMW General | Top of Page | What's New | My Stuff


