X5 Rear Wheel Camber
X5 Rear Wheel Camber
Author
Discussion

slf2012

Original Poster:

313 posts

177 months

Wednesday 23rd May 2012
quotequote all
I have a 2006 (56 plate) X5, and have just had to change the tyres due to wear on the inside of both rear tyres.

The outside of the tyres still had massive amounts of tread on them, it was only the inside 1/5th of the tyre which was badly worn.

The tyres are Bridgestone Duellers and have been on there for about 2 years, about 20k miles.

I've always noted that the car ran with a lot of negative camber on the rears, but that has been the case since new, and the previous set of tyres had a more even wear pattern over the width of the tyre.

My obvious thought is that the negative camber has caused the damage, but I'm wondering if there might be something else that needs checking?

Appreciate any advice!


mr.man

511 posts

247 months

Wednesday 23rd May 2012
quotequote all
Very common for this to happen. Apparently with the right gear you can have adjustments made to correct it.
As you said ,it's difficult to spot without crawling under the car to look. I was through to the canvas on two occasions.

8Tech

2,221 posts

229 months

Friday 25th May 2012
quotequote all
It is not the camber that will cause the inner tyre wear but incorrectly set rear toe.

You need to carefully check the rear subframe mounting bushes, usually shot from around 40,000m and replace as necessary. Then have a full KDS wheel alignment done and this will make sure all your settings are within spec, including rear toe and camber, both of which are adjustable.

I wouls also add 20,000m is very acceptable for rear tyres on an X5 regardless of engine choice.

You may also want to try dumping the run-flats if fitted because the excessively stiff sidewalls will exacerpate the wear. try standard replacements, they are quieter, grippier, can be repaired if punctured and are half the price.

RALEX72

22 posts

178 months

Saturday 2nd June 2012
quotequote all
I had an 05 X5 that went the same way.

Put new tyres on, and had the tracking reset. The rear camber was 1 degree out on both sides.

Makes sure you have a fourway tracking machine do the job.

20,000 is excellent for a set of rears.

slf2012

Original Poster:

313 posts

177 months

Tuesday 3rd July 2012
quotequote all
Thanks for the feedback guys. I've had the subframe mounting bushes checked and they appear to be fine.

Does anyone know what the the camber and toe-in or out should be on the rear wheels?