E90 rear brake pads cost
Discussion
Idrive showing up I need them in 2k miles.
What should I pay at BMW for this?
Rear pads have lasted c35k miles and visually looking at the discs they are fine so guess will get a other set of pads to this disc.
Oddly the front brakes have >30k miles to go.... Discs and pass were brand new when I bought it. I do use cruise control a lot though.
Also how much are discs as pads?
Do BMW do cheaper deals for this with cars over 4 years? Mine being a 2006 reg.
What should I pay at BMW for this?
Rear pads have lasted c35k miles and visually looking at the discs they are fine so guess will get a other set of pads to this disc.
Oddly the front brakes have >30k miles to go.... Discs and pass were brand new when I bought it. I do use cruise control a lot though.
Also how much are discs as pads?
Do BMW do cheaper deals for this with cars over 4 years? Mine being a 2006 reg.
Panda76 said:
Guesstimates.
£70-80 for decent pads maybe £100 for an hours labour even though it won't take an hour plus the VAT.
Over £200 quid easy.
Personally I would use a local reputable tyre/brake place (not kwikfit lol) who will fit BMW parts with a lot less labour charge and do the same job.
How do those garages reset the idrive for the rear brake servicing?£70-80 for decent pads maybe £100 for an hours labour even though it won't take an hour plus the VAT.
Over £200 quid easy.
Personally I would use a local reputable tyre/brake place (not kwikfit lol) who will fit BMW parts with a lot less labour charge and do the same job.
There is reset instructions on the internet for both I drive and non I drive.
If they don't do it then you can easily do it yourself.The info is automatically stored on the key.
Fortunately the tyre/brake place I use has an ex BMW fitter there who knows how to do the resets.
Takes less than 20 seconds to access non I drive service menus.
If they don't do it then you can easily do it yourself.The info is automatically stored on the key.
Fortunately the tyre/brake place I use has an ex BMW fitter there who knows how to do the resets.
Takes less than 20 seconds to access non I drive service menus.
Just had mine done, 330i. They lasted over 60k, the fronts still have loads left in them according to I drive.
BMW quoted £220 just for the rear pads! (They quoted over £400 for the discs too, which didn't need doing.)
You can get them done for less than half that, no point paying BMW rates for consumables, wouldn't get tyres off them would you?
Point to remember is you will need the pad sensors too or the I drive will always show 2k left until the new pads wear down to the same level. As has been said you can reset the I drive yourself with info off 'tinternet.
BMW quoted £220 just for the rear pads! (They quoted over £400 for the discs too, which didn't need doing.)
You can get them done for less than half that, no point paying BMW rates for consumables, wouldn't get tyres off them would you?
Point to remember is you will need the pad sensors too or the I drive will always show 2k left until the new pads wear down to the same level. As has been said you can reset the I drive yourself with info off 'tinternet.
Rear pads (you'd need to check they are the correct ones for your car):
http://www.ebay.co.uk/itm/BMW-Genuine-Rear-Brake-P...
Sensor (check correct one etc):
http://www.ebay.co.uk/itm/BMW-Genuine-Rear-Brake-P...
You can get non BMW parts for less. We used to charge 30 mins labour at a main dealer to change rear pads. Since CBS this is likely to have increased due to the handbrake shoe check, see below.
CBS models: What's checked or changed when this symbol appears?
Brake pads are changed, and the brake caliper cavities are cleaned. Failure to get your brake pads matched correctly will result in a brake imbalance front to rear on your vehicle, and if the callipers are cleaned, any squeaking in the brakes should be diminished.
Brake discs:- Surface and thickness - the importance of having a safe level of thickness in your brake discs is paramount to your driving safety; if necessary, the brake discs will be replaced.
Handbrake:
Condition, brake lining thickness and function - unlike the foot brakes, the handbrake is a mechanical function and therefore has to be checked for any necessary adjustment. As the handbrake is connected to the rear brake shoes, over time these shoes wear and therefore these will also require inspection to ensure a serviceable condition. (The brake shoes when applied by the handbrake clamps the drums of the rear brake disc, therefore securing the rear wheels in a locked position, the mating surfaces have to be in good order).
If necessary, the handbrake or any of its other components will be replaced.
Reset indicator
Hope this helps.
http://www.ebay.co.uk/itm/BMW-Genuine-Rear-Brake-P...
Sensor (check correct one etc):
http://www.ebay.co.uk/itm/BMW-Genuine-Rear-Brake-P...
You can get non BMW parts for less. We used to charge 30 mins labour at a main dealer to change rear pads. Since CBS this is likely to have increased due to the handbrake shoe check, see below.
CBS models: What's checked or changed when this symbol appears?
Brake pads are changed, and the brake caliper cavities are cleaned. Failure to get your brake pads matched correctly will result in a brake imbalance front to rear on your vehicle, and if the callipers are cleaned, any squeaking in the brakes should be diminished.
Brake discs:- Surface and thickness - the importance of having a safe level of thickness in your brake discs is paramount to your driving safety; if necessary, the brake discs will be replaced.
Handbrake:
Condition, brake lining thickness and function - unlike the foot brakes, the handbrake is a mechanical function and therefore has to be checked for any necessary adjustment. As the handbrake is connected to the rear brake shoes, over time these shoes wear and therefore these will also require inspection to ensure a serviceable condition. (The brake shoes when applied by the handbrake clamps the drums of the rear brake disc, therefore securing the rear wheels in a locked position, the mating surfaces have to be in good order).
If necessary, the handbrake or any of its other components will be replaced.
Reset indicator
Hope this helps.
Welshbeef said:
So over £200 easy just for rear pads?
How much would new pads and discs all round be then??£1k plus
Forgive the thread necromancy.How much would new pads and discs all round be then??£1k plus
I just found this thread, since the rear pads on my car need replacing in a thousand miles or so I've been checking out what's what. Maybe this will be helpful in future to someone.
My car is just over 4 years old (built 04/2011). It's an LCI E90 320d ED.
BMW charge £169 to do a set of pads on the rear, including parts, labour and VAT for cars over 4 years. This struck me as quite steep for a set of pads.
A set of rear pads from ECP (just for reference) costs the following (inc. VAT and free delivery) -
Eicher 19.46
Pagid 26.32 (part of TMD group)
ATE 31.80
Bosch 41.94
Textar 62.38 (part of TMD group)
The BMW OEM spec pads are made by Textar (BMW part 34216774692 for the replacement kit).
In addition to pads, you need new brake sensors, and brake pad paste.
If the car is over 48 months old a new retaining spring is also recommended as part of the service procedure; below that you can reuse the old one.
The pad wear sensors (also from ECP for example prices) are from either Pagid or Bosch, and on my age of car are priced per sensor as follows:
Pagid 9.07
Bosch 15.06
..so using all Pagid bits for example, the price could be (26.32+(2x 9.07)) = £44.57 plus paste and spring. All of a sudden £169 from BMW sounds like quite a lot.
Using all BMW OEM spec bits (textar pads + bosch sensors), it's more like £92.50 in parts only.. at which point £169 including fitting doesn't sound all that bad.
I'm probably going to just suck it up and get BMW to replace them as I'm thinking of selling the car later this year and I like the idea of a full BMW service history to go with it, but that's just me. As with all things, your mileage may vary.
(More than a year passes...)
Just to update this, I never actually needed to fit new pads.
The sensors are fine, the pads and discs both have loads of wear left.
What I've found is that BMW have programmed the brake wear indicator to count down irrespective of brake usage, based on mileage, AS WELL as by the sensed wear via the depth sensors on the brakes.
My car is still on its original pads and discs, at 85000 miles.
It has had the brake wear counter reset twice during this time, both times for the rear axle.
It's very easy to reset the countdown, takes about 20 seconds (just hold down the odo reset button for a specified amount of time - about 8s? at startup to get to the menu).
I was lucky and had a BMW main dealer look at mine and after I'd asked for the work to be carried out to replace some pads on the rear, they phoned me and gave me the actual values for wear in mm and told me it was an unnecessary piece of work. Hats off to them for that, I'm sure a lot of places would just replace everything to make a delicious big bill.
Just to update this, I never actually needed to fit new pads.
The sensors are fine, the pads and discs both have loads of wear left.
What I've found is that BMW have programmed the brake wear indicator to count down irrespective of brake usage, based on mileage, AS WELL as by the sensed wear via the depth sensors on the brakes.
My car is still on its original pads and discs, at 85000 miles.
It has had the brake wear counter reset twice during this time, both times for the rear axle.
It's very easy to reset the countdown, takes about 20 seconds (just hold down the odo reset button for a specified amount of time - about 8s? at startup to get to the menu).
I was lucky and had a BMW main dealer look at mine and after I'd asked for the work to be carried out to replace some pads on the rear, they phoned me and gave me the actual values for wear in mm and told me it was an unnecessary piece of work. Hats off to them for that, I'm sure a lot of places would just replace everything to make a delicious big bill.
CraigyMc said:
(More than a year passes...)
Just to update this, I never actually needed to fit new pads.
The sensors are fine, the pads and discs both have loads of wear left.
What I've found is that BMW have programmed the brake wear indicator to count down irrespective of brake usage, based on mileage, AS WELL as by the sensed wear via the depth sensors on the brakes.
My car is still on its original pads and discs, at 85000 miles.
It has had the brake wear counter reset twice during this time, both times for the rear axle.
It's very easy to reset the countdown, takes about 20 seconds (just hold down the odo reset button for a specified amount of time - about 8s? at startup to get to the menu).
I was lucky and had a BMW main dealer look at mine and after I'd asked for the work to be carried out to replace some pads on the rear, they phoned me and gave me the actual values for wear in mm and told me it was an unnecessary piece of work. Hats off to them for that, I'm sure a lot of places would just replace everything to make a delicious big bill.
That's a good rate of wear, presumably lots of motorway stuff?Just to update this, I never actually needed to fit new pads.
The sensors are fine, the pads and discs both have loads of wear left.
What I've found is that BMW have programmed the brake wear indicator to count down irrespective of brake usage, based on mileage, AS WELL as by the sensed wear via the depth sensors on the brakes.
My car is still on its original pads and discs, at 85000 miles.
It has had the brake wear counter reset twice during this time, both times for the rear axle.
It's very easy to reset the countdown, takes about 20 seconds (just hold down the odo reset button for a specified amount of time - about 8s? at startup to get to the menu).
I was lucky and had a BMW main dealer look at mine and after I'd asked for the work to be carried out to replace some pads on the rear, they phoned me and gave me the actual values for wear in mm and told me it was an unnecessary piece of work. Hats off to them for that, I'm sure a lot of places would just replace everything to make a delicious big bill.
My 530D will be three next March and is due to have the rear pads done in 3000 miles, at about 31000 according to the idrive. The fronts are said to be due about 3000 miles after that.
Looking at them physically, the rear would seem about right but the fronts have loads of life in them, far more than the idrive suggests.
I had a VW CC before. Sold at 62000 with 50% wear on rears, 70% wear on fronts at the 60k service.
Slightly puzzled about why the 5 hammers its rears so badly. Does the cruise and the small caliper size make that big a difference?
helix402 said:
Brakes are used for traction control, hence applied more on rear of rwd car.
I doubt that would be relevant in my case, the car gets a very steady, easy life in that respect. Witness to that the original tyres look good for at least 40K. I think if TC was responsible for heavy pad wear, the tyres would show greater wear than they do. Gassing Station | BMW General | Top of Page | What's New | My Stuff


