1996 E34 instrument cluster issue (LCD)
1996 E34 instrument cluster issue (LCD)
Author
Discussion

SuperchargedVR6

Original Poster:

3,138 posts

251 months

Tuesday 12th June 2012
quotequote all
I'm not sure if this forum is very technical or not, but I'll try anyway!

The LCD panel in my 525i's instrument cluster has started behaving erratically. Sometimes the text is garbled and sometimes the panel does't work at all. And then it will just suddenly work again.

I've already taken the clocks apart and there is no 'ribbon cable' that afflicts the E39 in the same way. It's just a module that clips into the main board with a rigid connector.

Just wondering if anyone's come across this before and if there's a well known dry joint or component that needs attention?

Thanks

Huff

3,448 posts

222 months

Tuesday 12th June 2012
quotequote all
There are couple of elexctrolytic capacitors on the board that dry out over time and cause this. Should be a straightforward bit of DIY if you have a soldering iron.

Frances The Mute

1,816 posts

272 months

Tuesday 12th June 2012
quotequote all
As above. It's a common failure on these cars.

A decent autospark should be able to resolve this in an hour or so if you're unsure of what to do.

SuperchargedVR6

Original Poster:

3,138 posts

251 months

Tuesday 12th June 2012
quotequote all
Thanks guys. Not as bad as I thought then!

Huff

3,448 posts

222 months

Tuesday 12th June 2012
quotequote all
Just to add in case you don't lay with electronics often - the parts values are not critical* and you'll find all you need at Maplin. Pick a cap of the same capacitance ('uF' marking) as those fitted and the same or higher voltage rating - I'd suggest 25v minimum. Do check/match the orientation when fitting because electrolytic caps are polarised for voltage and very intolerant of being hooked up the wrong way round.


  • electrolytic capacitance tolerances are pretty horrible; +50, -25% is about normal - hence my comment it's not critical. If in doubt, go slightly larger.

SuperchargedVR6

Original Poster:

3,138 posts

251 months

Tuesday 12th June 2012
quotequote all
Excellent, thanks again. Should I just find all the Electrolytics and just replace them regardless, or are there some specific ones I need to replace? Probably won't hurt doing all of them I guess? I am pretty experienced with soldering so it shouldn't be too much of an problem for me.

Once that's done, I then need to fix the LKM module which keeps telling me all my bulbs are out, when they're not!


Frances The Mute

1,816 posts

272 months

Tuesday 12th June 2012
quotequote all
SuperchargedVR6 said:
Once that's done, I then need to fix the LKM module which keeps telling me all my bulbs are out, when they're not!
Check the terminals and bulbs that the computer is warning you about before you start cracking the LKM open.

The terminals can corrode (especially number plate lights) and old bulbs can get pretty ropey, too.
LKM's are often said to be problematic but I've rarely seen them be the root cause of failure.

Huff

3,448 posts

222 months

Tuesday 12th June 2012
quotequote all
Agree with that from experience. The other thing to try is just unplugging the headlight motors. In fact, I'd recommend you try this first.

Weird but true - this cured a nag on my LKM persisting even after I'd cleaned-off, refluxed and re-flowed all the relay solder joints (though none appeared damaged under a loupe) and replaced the smoothing cap on it!