M62TU 'Jesus' (crank) bolt
M62TU 'Jesus' (crank) bolt
Author
Discussion

RockyBalboa

Original Poster:

768 posts

192 months

Thursday 14th June 2012
quotequote all
All,

Any opinions on what I can lock the crank with if I do not have the official locking pin (obviously, I do not want to damage the flywheel/plate).

Cheers.

iSore

4,011 posts

175 months

Friday 15th June 2012
quotequote all
You don't use the locking pin for that- you'll just snap the end off in the flywheel. You need the proper tool that bolts to the front of the crank once the front pulley has been removed (eight 13mm bolts). This long bar then bolts to the crank using longer bolts and rests on the chassis rail to lock the engine whilst you swing on a big breaker bar to loosen the bolt. 3/4 inch drive stuff is recommended.

RockyBalboa

Original Poster:

768 posts

192 months

Friday 15th June 2012
quotequote all
So when is the locking pin used?

Cheers.

iSore

4,011 posts

175 months

Friday 15th June 2012
quotequote all
The locking pin is to lock the crank at TDC along with tools to lock the cams in position for when you're doing timing chain related stuff, i.e taking the head(s) off. Unlike the old stuff (M20's etc) there are no timing marks on the V8's, M50's, M42's etc.