635d with huge ground clearance!
635d with huge ground clearance!
Author
Discussion

ben_ek

Original Poster:

56 posts

241 months

Wednesday 20th June 2012
quotequote all
i've just bought a 635d sport and it is pretty smooth so far, but i am confused with the ground clearance as it is running very high - there is literally 3 inches of clear air between the tyre and the wheel arch. is this normal? is there a way to adjust the ride height with the standard shocks? i've looked at eibach lowering springs but they only drop by an inch so this would not be enough...

thanks for your help.

rassi

2,518 posts

282 months

Wednesday 20th June 2012
quotequote all
Sure you didn't buy an X6 by mistake...?

Seriously, 3 inches is too much, clearance should be 1, 1.5 inches max. Is it the same on all 4 corners?

Egbert Nobacon

2,835 posts

274 months

Wednesday 20th June 2012
quotequote all
Sure its not a "non sport" 635d with sport alloys put on.....

Cheib

25,484 posts

206 months

Wednesday 20th June 2012
quotequote all
Hmmm. Was it brand new ? Have they left the blocks they put in the suspension during shipping in ? Heard of that once before.......

ben_ek

Original Poster:

56 posts

241 months

Wednesday 20th June 2012
quotequote all
it's a 2009 and is definitely a sport (verified on the hpi check too). it has a bmw service history -i guess the would pick up on the blocks being in there, is there an easy way of checking this? my drive is on a hill - i've remeasured it and the gap is 2" plus on all four corners.

Aeroresh

1,429 posts

263 months

Thursday 21st June 2012
quotequote all
Photos?

rassi

2,518 posts

282 months

Thursday 21st June 2012
quotequote all
Could you also post the tyre sizes?

Is it ground clearance or distance between tyre and arch that is the problem?

ben_ek

Original Poster:

56 posts

241 months

Thursday 5th July 2012
quotequote all
i've been to bmw and it turns out that the post 2007 facelift e63 rides higher than the earlier ones, the difference is quite noticeable when side by side, around 20mm, but normal. i assume the h&r lowering springs will lower to the height of the pre-facelift model -30mm so around 50mm on mine - does anyone know if this is the case? or does anyone have any photos of facelift 6 series on h&r springs and 19" alloys?

Edited by ben_ek on Thursday 5th July 22:02