E36 Coupe Window Problem
E36 Coupe Window Problem
Author
Discussion

Steve126

Original Poster:

304 posts

214 months

Tuesday 10th July 2012
quotequote all
My Dad has an E36 coupe and the passenger door window won't open. The window doesn't drop slightly when you open the door the way it should and when you push the button to open the window you can hear a click but the window doesn't move.

He has tried putting the switch from the driver's window on the passenger side but that made no difference so we know the switch is ok. A BMW mechanic said corrosion was likely to be the problem, but having removed the interior door panel we can see no signs of rust/ corrosion on the mechanism or anywhere else.

Is it likely to be the motor causing the problem, worn regulator or something else?

I'd be grateful for any suggestions.

E30M3SE

8,493 posts

227 months

Tuesday 10th July 2012
quotequote all
If there's no corrosion on the regulator and it all looks good, and the motor is receiving power when the button is pressed then most likely the motor itself.

The motor is a separate part to the reg, so you can remove the motor and test in isolation to rule out any reg issues.

lewis328

508 posts

229 months

Friday 13th July 2012
quotequote all
Hi it will be the motor for sure, i had exact same problem a few years ago on my 328, test motor like mentioned above. I got the motor from Euro car parts stright swap, obviously test new motor prior to fitting.

The Nur

9,168 posts

216 months

Friday 13th July 2012
quotequote all
I agree it is probably the motor. I have had this problem before though (admittedly in a Golf) where the cable needed to be jimmied into the motor housing a bit and it worked fine after.

helix402

7,913 posts

213 months

Friday 13th July 2012
quotequote all
It does sound like the motor. It may sound brutal but it may work for a short time if you give it a bash (loose internal connection).

Steve126

Original Poster:

304 posts

214 months

Tuesday 17th July 2012
quotequote all
It stopped raining today so we finally had the chance to fit a new motor and it solved the problem, as you all thought it would.

Thank you.

Edited by Steve126 on Tuesday 17th July 18:26