Z4 (E85) 2.0 vs 2.5 vs 3.0 - I'm suprised.
Discussion
Hi All
I have been in contemplation of buying a sub £10k sportscar for a few weeks or so and having been to see a few I am now set on getting a BMW Z4 (E85).
However, having driven a few cars now I'm somewhat supirsed at my conclusions and thought I would take a minute to share them.
I have driven a 2.0, 2.5 and 3.0 car and weirdly the one I ended up liking the most in terms of driving was actually the 2.0. It felt far more agile in the corners presumably due to it being only a 4 cylinder and wasn't noticeably slower in terms of acceleration than the 2.5. The steering seemed far more direct and I had far more confidence in the bends.
Both the 2.5 and 3.0 cars had lots of low end torque and plenty of power but the understeer and ride put me off a fair bit. I also think that the 3.0 is most likely out of my budget as the ones I have seen have been a bit ropey in comparison.
I am used to driving older sportscars (like my old Spitfire) along with an s1 elise around and I guess the 2.0 felt the most similar to drive. When you combine that with the cheaper running costs and avaliability of the 2.0 it seems to me to be a good choice.
I thought I would just share my experience with you and fully expect that most of you will tell me I am insane, perhaps I'm not the only one?
Thanks
I have been in contemplation of buying a sub £10k sportscar for a few weeks or so and having been to see a few I am now set on getting a BMW Z4 (E85).
However, having driven a few cars now I'm somewhat supirsed at my conclusions and thought I would take a minute to share them.
I have driven a 2.0, 2.5 and 3.0 car and weirdly the one I ended up liking the most in terms of driving was actually the 2.0. It felt far more agile in the corners presumably due to it being only a 4 cylinder and wasn't noticeably slower in terms of acceleration than the 2.5. The steering seemed far more direct and I had far more confidence in the bends.
Both the 2.5 and 3.0 cars had lots of low end torque and plenty of power but the understeer and ride put me off a fair bit. I also think that the 3.0 is most likely out of my budget as the ones I have seen have been a bit ropey in comparison.
I am used to driving older sportscars (like my old Spitfire) along with an s1 elise around and I guess the 2.0 felt the most similar to drive. When you combine that with the cheaper running costs and avaliability of the 2.0 it seems to me to be a good choice.
I thought I would just share my experience with you and fully expect that most of you will tell me I am insane, perhaps I'm not the only one?
Thanks
Sortie 10 said:
Whatever you do, make sure the roof works well. It looks as if I could be in for a major bill on my 50000 mile 2003 car - BMW deserve a gold medal for making the motor so inaccessible & difficult to repair/replace. Not happy at the moment...
A friend of mine works for BMW apparently there is a company that can provide aftermarket motors. He said they fitted them the other day at work and total bill was around £270. I'll find out who it is. Did you try the 2.0 or the 2.2? The 2.0 was only available post facelift, 2006 on and a 4 cyl; the 2.2 is 6 cyl from 04 iirc.
I remember the 2.2 got good write-ups at the time because it was perceived as more nimble, as you describe.
Handling on my 3.0 is much sharper since getting rid of rfts, so with/without rfts will affect your comparison as much as anything I'd have thought.
I remember the 2.2 got good write-ups at the time because it was perceived as more nimble, as you describe.
Handling on my 3.0 is much sharper since getting rid of rfts, so with/without rfts will affect your comparison as much as anything I'd have thought.
Sticks. said:
Did you try the 2.0 or the 2.2? The 2.0 was only available post facelift, 2006 on and a 4 cyl; the 2.2 is 6 cyl from 04 iirc.
I remember the 2.2 got good write-ups at the time because it was perceived as more nimble, as you describe.
Handling on my 3.0 is much sharper since getting rid of rfts, so with/without rfts will affect your comparison as much as anything I'd have thought.
I drove a 56 plate 2.0 4 cylinder. You could tell it was definitely a 4 cylinder because it did look a little lost in the bonney in comparison to the 2.5.I remember the 2.2 got good write-ups at the time because it was perceived as more nimble, as you describe.
Handling on my 3.0 is much sharper since getting rid of rfts, so with/without rfts will affect your comparison as much as anything I'd have thought.
I hear what you are saying with regards the RFT's but the 2.0 had them on too, so surely if you were to remove them from that you would experience a similar increase in turning ability?
All Z4's are very reliable,the odd roof motor and broken spring is about all that seems to go wrong.Go and have a look on the Porsche forum,you'll weep with the tales of big engine bills, top end rebuilds and clutches at 40,000 miles.Properly scary,and poor ,for a perceived quality German marque.The 2.0 is a great car, get yourself a nice one and you'll be very happy with it.Ditto the runflats,the ride with normal tyres is much better.
DazBock said:
A friend of mine works for BMW apparently there is a company that can provide aftermarket motors. He said they fitted them the other day at work and total bill was around £270. I'll find out who it is.
Would really appreciate this - and would be prepared to travel (I'm near Bristol) if I could save a pot of cash (my local main dealer was quoting around £100 just to diagnose the fault!)Sortie 10 said:
Would really appreciate this - and would be prepared to travel (I'm near Bristol) if I could save a pot of cash (my local main dealer was quoting around £100 just to diagnose the fault!)
My mate is service manager at a BMW dealership in Bedfordshire. He tells me the drain plugs get clogged which results in the motor being submerged and shorting out. Apparently it is a £1000 job at BMW but the parts came from a place in wembley and labour cost a few hundred. He can't remember name but he is checking it out. DazBock said:
Sortie 10 said:
Would really appreciate this - and would be prepared to travel (I'm near Bristol) if I could save a pot of cash (my local main dealer was quoting around £100 just to diagnose the fault!)
My mate is service manager at a BMW dealership in Bedfordshire. He tells me the drain plugs get clogged which results in the motor being submerged and shorting out. Apparently it is a £1000 job at BMW but the parts came from a place in wembley and labour cost a few hundred. He can't remember name but he is checking it out. 2.0/2.2/2.5/3.0 performance on paper is largely different, but I agree (from lots of experience) that on the road there's not as much in it as you'd expect. I had a pre-facelift 3.0 231ps and was regularly out on drives with plenty of 2.0 owners. They didn't ever really struggle...
blippo1984 said:
I have a 2.0.
Lovely car and you can afford o be pretty aggressive on price when buying too as there are quite a few hovering in that price range.
This is the sort of thing I am looking at, shame the pictures are crapLovely car and you can afford o be pretty aggressive on price when buying too as there are quite a few hovering in that price range.
http://pistonheads.com/sales/4152390.htm
DazBock said:
My mate is service manager at a BMW dealership in Bedfordshire. He tells me the drain plugs get clogged which results in the motor being submerged and shorting out. Apparently it is a £1000 job at BMW but the parts came from a place in wembley and labour cost a few hundred. He can't remember name but he is checking it out.
The good news is it's a 15 minute job to clear the drain plugs as they're easily accessed from the wheel arch.There's a flap at the front of each wheelarch liner, a few bolts and that's off, reach forward & up inside the flap and you'll feel the spongy rubber plug, whip it out and poke a piece of speaker cable / straightened coathanger up then flush from the top and replace plug.
Everybody has there own opinion & you've goota go with what your happy with. For me i just had to go for the 3.0 Z4 (E85) as i love the smoothness of the straight 6 engines & it just purrs along ! Also to me its not a proper Bmw unless it has the straight 6 in, but then thats my opinion & thats why i bought it !
HerrSchnell said:
The good news is it's a 15 minute job to clear the drain plugs as they're easily accessed from the wheel arch.
There's a flap at the front of each wheelarch liner, a few bolts and that's off, reach forward & up inside the flap and you'll feel the spongy rubber plug, whip it out and poke a piece of speaker cable / straightened coathanger up then flush from the top and replace plug.
This could be the very reason why my motor has failed. The car runs on 18" wheels & has M-sport lowered suspension - the clearance between wheels & arches is very low and jobs of this nature (like adjusting headlights for continental driving) are a right royal PITA; will check the service manual as this should be a routine service item. Is there a way of clearing the drains from above? (you could on the MX-5, the car I traded for the Z4)There's a flap at the front of each wheelarch liner, a few bolts and that's off, reach forward & up inside the flap and you'll feel the spongy rubber plug, whip it out and poke a piece of speaker cable / straightened coathanger up then flush from the top and replace plug.
Sortie 10 said:
This could be the very reason why my motor has failed. The car runs on 18" wheels & has M-sport lowered suspension - the clearance between wheels & arches is very low and jobs of this nature (like adjusting headlights for continental driving) are a right royal PITA; will check the service manual as this should be a routine service item. Is there a way of clearing the drains from above? (you could on the MX-5, the car I traded for the Z4)
Get yourself on z4-forum and have a search - there's some guides on there I think. I believe you still need to access the bottom of the drain, but it's made easier by jacking up the rear of the car. I was able to drain them with 18"s and Eibach Pro springs (another 15mm lower than M-Sport) although removing the wheels does make it far easier.illmonkey said:
Don't forget to alter the noise generator. It makes a massive difference in noise, especially at full chat.
Not in the 2.0/2.2 it doesn't - they don't have it. Not sure if the 2.5 does either, but the 3.0 does as standard. In the end I'd completely removed one piece of foam and half of the other bit - lovely 
Gassing Station | BMW General | Top of Page | What's New | My Stuff


