E36 dash fault
Discussion
Last week the fuel guage was sitting just above the 1/4 tank mark and suddenly just fell to completely empty. I put more fuel in and it rose to 3/4 tank for around 5 seconds and then just dropped to empty again.
Then yesterday the temp guage just dropped to zero temp also and does not raise at all now. The airbag light used to be on after seat removal and that does not light anymore either.
Is this a dash fault or is it individual faults. Any help would be greatly appreciated.
Then yesterday the temp guage just dropped to zero temp also and does not raise at all now. The airbag light used to be on after seat removal and that does not light anymore either.
Is this a dash fault or is it individual faults. Any help would be greatly appreciated.
Yeah, possibly. I've been having brake light trouble with mine and I found a link to another chap who had the fuel gauge and temperature gauge go along with his brake lights. He traced it to a fuse which had blown (fuse 46).
But if your brake lights (two of them anyway) are working, then perhaps that's not the problem for your car.
The instrument cluster is still a common problem on E36s so it's worth looking at regardless.
But if your brake lights (two of them anyway) are working, then perhaps that's not the problem for your car.
The instrument cluster is still a common problem on E36s so it's worth looking at regardless.
I changed fuse 46 today and the instrument binnacle came back to life. The fuel gauge and temperature gauge are as right as rain now.
Strangely, I could see nothing wrong withe old fuse but the new one has done the trick. Worth swapping it for another before you go down the route of a new set of clocks.
Strangely, I could see nothing wrong withe old fuse but the new one has done the trick. Worth swapping it for another before you go down the route of a new set of clocks.
isleofthorns said:
i have a spare cluster, but was out of a late 318is... not sure if they are common parts
the 4 and 6 cylinder clusters are not interchangeable as the signal going to the rev counter is different.or the rev counter will be showing about 3k rpm on idle
It may sound unrelated but check the wiring going from the body to the boot lid, the wires break inside the cover and short against each other causing all sorts of trouble
jamesson said:
It's your instrument cluster. Common fault. I have the same problem right now and bought a replacement on eBay for £25 including P&P. Brand new price £536.82. 
Easy job to replace and you don't need to remove the steering wheel to swap them over.
o/t are they that easy? I've got my right indicator bulb out (in dash) and figured id have to remove the steering wheel etc so havent bothered.
Easy job to replace and you don't need to remove the steering wheel to swap them over.
It's a bit tricky the first time, but once you see how the clips work, it's quite simple.
First of all, lower the steering wheel to its lowest position. That makes things a bit easier.
Two torx screws at the top of the binnacle then gently prise it out of its position. There are three clips to undo and they're held in place a bit like the barriers that come down over your head on a roller coaster. If you feel around, you can get an idea what it looks like.
To get it to release though, you have to push in a bit of plastic which locks the loop in place. Once you release one, you'll get a better idea how to release the other two. My recommendation is to release the one closest to the centre of the dash first as I found that the easiest.
Once they're all released, move the binnacle to the left and although it's a tight fit, it will slide out. You might need to wiggle the wheel to help it on its way. I've done it a few times now and it takes about ten minutes.
First of all, lower the steering wheel to its lowest position. That makes things a bit easier.
Two torx screws at the top of the binnacle then gently prise it out of its position. There are three clips to undo and they're held in place a bit like the barriers that come down over your head on a roller coaster. If you feel around, you can get an idea what it looks like.
To get it to release though, you have to push in a bit of plastic which locks the loop in place. Once you release one, you'll get a better idea how to release the other two. My recommendation is to release the one closest to the centre of the dash first as I found that the easiest.
Once they're all released, move the binnacle to the left and although it's a tight fit, it will slide out. You might need to wiggle the wheel to help it on its way. I've done it a few times now and it takes about ten minutes.
Gassing Station | BMW General | Top of Page | What's New | My Stuff


