Ditched the run flats - Advice on tyre pressures?
Ditched the run flats - Advice on tyre pressures?
Author
Discussion

318is boy

Original Poster:

106 posts

233 months

Wednesday 12th September 2012
quotequote all
Evening all, after some advice / opinions on what to do with tyre pressures having ditched the run flat tyres for normal tyres earlier today. For the time being I have put the manufacturers recommended for RFT in.

So, have you left the pressures the same as manufacturer recommendations for run flats or increased / decreased....

tim0409

5,985 posts

190 months

Wednesday 12th September 2012
quotequote all
I have just replaced my RF with NRF on my 118d and the general consensus on the 1 series forum seems to be that you increase tyre pressure to compensate for the difference in the rigidity of tyre side walls. I have been running them at +3psi over the book pressure on the fronts but still found the ride hard so have reverted back to normal and it seems better.

E38Ross

36,729 posts

243 months

Wednesday 12th September 2012
quotequote all
how has the ride quality changed?

Sticks.

9,726 posts

282 months

Thursday 13th September 2012
quotequote all
I added 0.1bar when I changed the 17s on a 120d M Sport, but no extra on the Z4's 18s. 17s were Continentals, 18s F1 Asymmetrics.

LeoSayer

7,865 posts

275 months

Thursday 13th September 2012
quotequote all
The sticker on the door pillar on my X5 states pressures for each possible tyre size, load and speed rating. It doesn't say anything about whether they are for run flats or not.

The extra stiffness and weight of the run flats doesn't given them any extra load bearing capacity when correctly inflated. IMO if the tyre size, loading rating and speed index are the same as the run flats then you should use the standard pressure.

That's what I did and the handling doesn't seem to have suffered in any way. The ride is massively improved on bumpy b-roads, smaller improvements everywhere else. I think it's purely because non run-flats are so much lighter, something like 5kg per corner. That is a massive reduction in unsprung weight.




Edited by LeoSayer on Thursday 13th September 12:35