Forcing a regen
Forcing a regen
Author
Discussion

leah1

Original Poster:

45 posts

186 months

Saturday 13th October 2012
quotequote all
Hi I need to force a regen on a friends car and have been reading up a bit on this subject,I'm about to buy a cable and software to do this but I do have acces to a fault code reader,I know a few people have had success with forcing a regen by constantly clearing the fault code on a drive, so this is an option for us, but what I want to know is,is this all the dealers do to get the cars to regen or do they use the dis and NSC expert software and if this is the case is there a specific section in this software that will start a regen immediately
Thanks

rumple

15,457 posts

182 months

Sunday 14th October 2012
quotequote all
Sorry op, i dont know what in the wide wide world of sports you are on about, is this a diesel thingconfused, regen whatconfused.

Jimbo666

53 posts

226 months

Sunday 14th October 2012
quotequote all
He means forcing a DPF regen.

I've done mine today. I hooked the laptop up and kept clearing the codes via INPA. My other half drove down the motorway while I sat with the laptop clearing.

You'll need to make sure the thermostats aren't up the shoot. The coolant/engine temp needs to be above 75degC and at least 10 litres of fuel in the tank.

Do some more reading up before you have a go to fully understand the software (what can be a pain to set up) and procedure. There's loads of bits on the specific BMW forums.

What car is it?

leah1

Original Poster:

45 posts

186 months

Sunday 14th October 2012
quotequote all
Hi it's a 320d m sport 58 plate,i have a scangauge that reads and clears fault codes also have checked the coolant temp and it warms up quick and is fine,as I say I can clear fault codes with the scangauge I have but all I wanted to know was is that all you do using the bmw software? Or is there a specific option in this software that will do all the work for you ?
Thanks

Jimbo666

53 posts

226 months

Monday 15th October 2012
quotequote all
I enabled a regen in DIS then just went for a drive clearing the codes as they appeared in INPA. I can't say if it'll work with Scan gauge as I'm not certain how they work. I can only say give it a go!

leah1

Original Poster:

45 posts

186 months

Wednesday 17th October 2012
quotequote all
When you say you enabled a regen what exactly did you do is there a section in there that you click which in turnsput the car into regen??
Thanks for your help

roofer

5,136 posts

242 months

Wednesday 17th October 2012
quotequote all
Is it not just a temp fix anyway?

eastsider

1,102 posts

254 months

Thursday 18th October 2012
quotequote all
Can't you just take it down a quiet dual carriage way for an 'italian tune up'?

leah1

Original Poster:

45 posts

186 months

Thursday 18th October 2012
quotequote all
Can't wont work when it's got a dpf fault code on it there's no point trying needs to be deleted

excel monkey

4,837 posts

258 months

Thursday 18th October 2012
quotequote all
Jimbo666 said:
I enabled a regen in DIS then just went for a drive clearing the codes as they appeared in INPA. I can't say if it'll work with Scan gauge as I'm not certain how they work. I can only say give it a go!
What is DIS and what is INPA?

Jimbo666

53 posts

226 months

Friday 19th October 2012
quotequote all
They are the BMW diagnostic programs but are easily obtainable on the net.