First Issue Hard Brakes 130i
First Issue Hard Brakes 130i
Author
Discussion

Crusoe

Original Poster:

4,126 posts

262 months

Thursday 18th October 2012
quotequote all
Its been very wet over the last week up here so thinking the weather might play a part, lots of puddles this morning but didn't go through anything more than an inch or two deep. Half way through the drive to work the brake pedal went solid (just as well the roads were quiet and I was rolling slowly towards a junction.) all assistance gone but can still get some braking if you apply a lot of force to the pedal.

Stopped and checked the brakes all round, disks all warm to the touch so all in use and no sticking calipers or items stuck that I could see. No warning lights on the dashboard so switched all the traction and stability off and drove slowly to work.

Will be out at lunch to check brake fluid level (expecting it all to be fine as it had a MOT and service a few weeks back), are there any fuses that cover the brake servo that need checked.

Quick Google turns up some issues with vacuum pumps on 06 onward valvetronic 6 cylinder engines and brake boosters failing if they get wet. Not sure if that explains the sudden loss of assistance or would be a gradual loss of vacuum. Anyone post an engine picture and mark the bits I should visually check before I call BMW assist and get them to take it away and sort it. Could it just be loose vacuum hose?

web said:
The late model BMWs that have the “N” series V12, V8 and 6-cylinder engines (most 2004/06-on BMWs and some earlier models) with the Valvetronic variable valve timing system, use an engine driven vacuum pump to supply vacuum for the power brake booster. The brake booster works similarly to a common vacuum operated power brake booster with the exception that the vacuum is originated by a pump rather than via intake manifold vacuum.

A somewhat common problem with these systems is a hard, or stiff, brake pedal. The diagnosis is typically either a faulty vacuum pump or a faulty booster. A few years ago BMW did perform a recall on various V8 & V12 models that use this system. The recall replaced the vacuum pump (due to leakage) and if oil was found in the vacuum booster, the booster was replaced. Now, a few years after the recall, we are seeing a common issue with the boosters failing, on all models (6-cylinder, V8 & V12), as well as continued pump failures. Sometimes there is oil in a failed booster, but not always.

Crusoe

Original Poster:

4,126 posts

262 months

Thursday 18th October 2012
quotequote all
Had a look at lunchtime, checked the wires, cleared the drainage and checked the fuses. Nothing obvious and it seems to be working again now so not sure what it was. A perished vacuum pipe closing under pressure or water getting in somewhere that it shouldn’t but has now dried out? Will drive slowly home and see if it reappears and maybe get it booked in for a check just encase. Usually problems that go on their own are a good thing but you like to trust that your brakes will work when needed.