airbag warning light e46
Discussion
I had to remove front seats and centre console to get carpet out in the rear to dry it. Kids drink bottle open under back seat and a week of a fan in the foot well made no difference!
Since then air bag light has been on. I thought I had pulled the wire out of crash sensor under the console when I refitted it. The hazard warning light switch cable was trapped under the carpet so i gave it a tug. I have since read on net about passenger seat occupancy detector. Can this be damaged just by taking the seat out, or simply disconnecting it make the light stay on. I have not had it reset or fault tested until I know what might have caused it.
Any advice would be gratefully received. I have MOT next week and it's a fail now.
BTW I know about pulling fuse 10 as a temp fix to turn off light and psod bypass unit.
Cheers Z
Since then air bag light has been on. I thought I had pulled the wire out of crash sensor under the console when I refitted it. The hazard warning light switch cable was trapped under the carpet so i gave it a tug. I have since read on net about passenger seat occupancy detector. Can this be damaged just by taking the seat out, or simply disconnecting it make the light stay on. I have not had it reset or fault tested until I know what might have caused it.
Any advice would be gratefully received. I have MOT next week and it's a fail now.
BTW I know about pulling fuse 10 as a temp fix to turn off light and psod bypass unit.
Cheers Z
On mine, the wiring to the seatbelt pre-tensioner under the drivers seat often causes the airbag light to come on (mine is a coupé, so it often gets upset when the driver's seat is folded forward).
Although the period of the fault lasts for a fraction of a second, once the light comes on, it won't go out again until I've cleared the fault code via diagnostics software. I tried disconnecting the battery/pulling fuses etc. - nothing worked.
Did you unplug the seatbelt pre-tensioner wiring from the loom, or perhaps disturb it when you took the seats out?
If you have a laptop, you can buy a USB cable/software on eBay for less than £30 which will plug in to the diagnostics port and allow you to read and clear codes. There's also a handy function on the BMW software (which mine came with) which gives you a live view of all the sensors on the airbag system and shows which ones are throwing a fault code. So you can wiggle cables until you find out which one is causing the problem
Although the period of the fault lasts for a fraction of a second, once the light comes on, it won't go out again until I've cleared the fault code via diagnostics software. I tried disconnecting the battery/pulling fuses etc. - nothing worked.
Did you unplug the seatbelt pre-tensioner wiring from the loom, or perhaps disturb it when you took the seats out?
If you have a laptop, you can buy a USB cable/software on eBay for less than £30 which will plug in to the diagnostics port and allow you to read and clear codes. There's also a handy function on the BMW software (which mine came with) which gives you a live view of all the sensors on the airbag system and shows which ones are throwing a fault code. So you can wiggle cables until you find out which one is causing the problem

I unplugged seat and took it out, so I assume all electrics, seat heating anti-submarine, and psod were disabled. So any of the airbag sensor stuff could have been affected. I don't have a laptop, and my experience of software off eBay never works with mac based computers.
but I know a man that could do diagnostic. So I probably need to check everything is plugged in and making good contact, then have it diagnosed! Cheers
but I know a man that could do diagnostic. So I probably need to check everything is plugged in and making good contact, then have it diagnosed! CheersGassing Station | BMW General | Top of Page | What's New | My Stuff


