Another E38 with a leaky fuel tank.
Discussion
Brimmed the tank on my E38 earlier and was rather irritated to see a constant dribble of fuel dropping from the back of the passenger side sill. Given that E38s are known for it and mine was acquired for bargain basement money, I thought it'd be something I'd have to deal with sooner or later.
What's confused me is that when I got home (10 miles later) the leak had stopped. Looking at pictures of E38 fuel tanks it seems the seal between the two halves of the pressings is around 3/4 the way up the tank, certainly further down than 10 miles of driving would drop the fuel level of a brim-full tank to. Question is, what's up on the top of the passenger side of the tank that could leak? Most of the pictures and info I've found refers to the V8/V12 models - apparently the 728i's were slightly different. Mine's a 2001 728i Sport if it makes any difference.
Any help is much appreciated, I think I'll be dropping the tank and buying some Pratley Putty during my week off in January.
What's confused me is that when I got home (10 miles later) the leak had stopped. Looking at pictures of E38 fuel tanks it seems the seal between the two halves of the pressings is around 3/4 the way up the tank, certainly further down than 10 miles of driving would drop the fuel level of a brim-full tank to. Question is, what's up on the top of the passenger side of the tank that could leak? Most of the pictures and info I've found refers to the V8/V12 models - apparently the 728i's were slightly different. Mine's a 2001 728i Sport if it makes any difference.
Any help is much appreciated, I think I'll be dropping the tank and buying some Pratley Putty during my week off in January.
I bought my 1998 728 on Sunday and yesterday found the same fuel leak in the same location. I thought getting it through the MOT would be enough but as it has been LPG converted he had the tank so low the leak wasn't evident.
I removed the passenger rear wheel and liner and you could see a pin prick hole just above the seam on the curve of the tank. I have put a bit of JB Weld Quiksteel on it and see if that fixes it. I can always run it on the LPG but the fact that all the tanks go is annoying. The fuel only leaked out when it was above a third full but as soon as it was below that line it was all good (apart from the vapours).
Has anyone any suggestions regarding a breakers replacement or to get a pattern one from Euro Car Parts (who are hit and miss for spares in my experience)?
I removed the passenger rear wheel and liner and you could see a pin prick hole just above the seam on the curve of the tank. I have put a bit of JB Weld Quiksteel on it and see if that fixes it. I can always run it on the LPG but the fact that all the tanks go is annoying. The fuel only leaked out when it was above a third full but as soon as it was below that line it was all good (apart from the vapours).
Has anyone any suggestions regarding a breakers replacement or to get a pattern one from Euro Car Parts (who are hit and miss for spares in my experience)?
E-bmw said:
I don't know the e38 intimately, but, if you say you brimmed it & it was leaking and 10 miles later it was not, I would say filler hose is your prime candidate & should be an easy fix. (Obviously apart from the bit where you MAY need to drop the tank to get at it)
Wrong side to be the filler pipe, though they are known to go there too where it enters the tank.I've got new rose joints to fit too so I think it'll be a job for a week off that I have in January. I'd like to replace the tank but I've just had the bill from the Steam Racket Company for taking my van to the Isle of Man for the TT, so funds just aren't there for that sort of outlay on top.
Frustrating but a common problem. I've had 3 e38s so think I must have been lucky.
I've seen these guys recommended for fuel tank repair / refurb;
http://www.fuel-tank-renu.co.uk/pages/tanks.html
I've seen these guys recommended for fuel tank repair / refurb;
http://www.fuel-tank-renu.co.uk/pages/tanks.html
It seems I may have been overly optimistic about the location of the leak. My wife has just phoned me to say the gauge is now reading half way, so I'm guessing it's gone along the seam. It's been 4 days since I filled it and parked it, so if it was low down I'd guess it would have lost the whole lot if it was leaking at the bottom by now. Also I've had it half full very recently with no issues.
Bugger.
Bugger.
Guys
I had this issue aswell on my E38 about a year ago. I found the solution online and got my BMW tech to try it. It worked perfectly and has remained leak free since then.
My leak was where the filler pipe comes into the tank; at the flange into the fuel tank they can leak.
Solution? Clean area with copper or brass brush when tank is virtually empty and degrease. Follow the instructions for this below;
http://www.ebay.co.uk/itm/1-x-Pratley-Original-Wat...
Mix as per instructions EXACTLY. Apply around area and allow to go off overnight before using.
Next day? Voila! Fixed cheaply and permanently.
I don't see why you couldn't use it on seams. It the perfect petrol proof repair solution.
Hope this helps.
I had this issue aswell on my E38 about a year ago. I found the solution online and got my BMW tech to try it. It worked perfectly and has remained leak free since then.
My leak was where the filler pipe comes into the tank; at the flange into the fuel tank they can leak.
Solution? Clean area with copper or brass brush when tank is virtually empty and degrease. Follow the instructions for this below;
http://www.ebay.co.uk/itm/1-x-Pratley-Original-Wat...
Mix as per instructions EXACTLY. Apply around area and allow to go off overnight before using.
Next day? Voila! Fixed cheaply and permanently.
I don't see why you couldn't use it on seams. It the perfect petrol proof repair solution.
Hope this helps.
Well it looks like I'll be doing this job this weekend - my tank is rogered and leaking from around the seams. I can't access parts of the leak so its off with the tank.
I'll keep this updated if there's interest? I plan to follow this guide
http://www.bimmerforums.com/forum/showthread.php?1...

I'll keep this updated if there's interest? I plan to follow this guide
http://www.bimmerforums.com/forum/showthread.php?1...

Noticed a petrol smell had it checked ,sure enough it seeping , and none available from breakers priced a new one £1060 plus the vat and it looks like i really will have to buy ,the only other option is to have it re-nu but that would necessitate driving nearly 300 hundred miles and if all didn't go to plan then stuck miles from home so the best option is to order a new one them mission completed in the day
Gassing Station | BMW General | Top of Page | What's New | My Stuff


