Need a Midlands Indy with electrical skills
Need a Midlands Indy with electrical skills
Author
Discussion

Slippydiff

Original Poster:

16,503 posts

254 months

Sunday 8th May 2016
quotequote all
Bought one of these for my E90 330D : http://www.burgertuning.com/paddleshift.html

and a paddleshift wheel off the bay of E recently.

Fitted it in short order yesterday afternoon. Doesn't work frown

Checked and double checked the install, but to no avail. I sent an email to Burger Motorsport in the States late yesterday afternoon, not expecting an answer until late on Monday. So was pleasantly surprised to receive a response within half an hour ! ! What brilliant customer service I thought...

Their email read :

"Hi, Unfortunately we don't offer support for items purchased second hand. Maybe ask the person you bought it from."

clap

So I now need to find a good Indy in the Midlands area that can diagnose what's wrong/why it doesn't work, and fix it.
No coding needed (that's the whole point of the retrofit kit) just someone with good old electrical diagnostic skills.

Any recommendations gratefully accepted.

Many thanks in advance. smile

Neil-y0jlk

47 posts

134 months

Sunday 8th May 2016
quotequote all
Not sure where in the Midlands you are but Stourbridge Automotive http://stourbridgeautomotive.co.uk/ have a good reputation, worth giving them a ring

f1nn

2,694 posts

223 months

Sunday 8th May 2016
quotequote all
I didn't realise you could get these, where does the loom plug into, I'm guessing the gearstick loom?

Slippydiff

Original Poster:

16,503 posts

254 months

Sunday 8th May 2016
quotequote all
Remove the airbag, steering wheel, lower steering column shroud and under dash trim. Then remove the auto gearbox shifte lever, its surround and the centre console top/trim.

With the lower steering column shroud removed, you remove one of the electrical multiplug connectors from the rear of the column switchgear and plug the Burger Tuning loom/multiplug into it instead, you then plug the original multiplug into the second (female) multiplug attached to the Burger Tuning loom.

The loom is then fed back and down underneath the heater box, that bit is a bit of a faff.... but I struck lucky after ten minutes of trying to thread the cable and its connectors through.

This leaves two small blue connectors on the Burger Tuning loom to plug into the the existing connectors alongside the gear shifter.
All should then work without ANY coding needed.

I'm not sure what the fault is, hopefully it will be easily sortable by a good, knowledgeable BMW sparky.

f1nn

2,694 posts

223 months

Sunday 8th May 2016
quotequote all
Let me know how you get on, and what the issue was, as I may be interested in doing this.

Theophany

1,069 posts

161 months

Monday 9th May 2016
quotequote all
Neil-y0jlk said:
Not sure where in the Midlands you are but Stourbridge Automotive http://stourbridgeautomotive.co.uk/ have a good reputation, worth giving them a ring
+1 for them, they look after my mum's 335i and are extremely competent. I use DTE Motoring Centre in Kidderminster for my 645ci and they've always been excellent.

home

38 posts

130 months

Wednesday 11th May 2016
quotequote all
Enda's a BMW guru in the midlands, I remember him retrofitting flappy paddles to an E60 so should be able to help with your retrofit