E46 Brake problem - please help!
Discussion
I am having a mare with my brakes. I got 2003 E46 (318i Auto) with N42 engine.
I was driving 30 mile route on country lanes (a lot of braking) when my brakes suddenly went slack. Pedal went all the way to the bottom and I had barely any brakes. ABS and Traction warning lights went on. - I stopped as soon as I could and just had to compose myself (and change underwear). I was stopped for 5 minutes or so. After which started the car and it was ok. Back to usual.
After inspectinf the engine bay I found fresh oil around vaccume pump. The fluid levels were normal. Pads and discs were only serviced a month prior to that (as part of full service).
Could anyone point me in the right direction? Googling about braking problems wasn't helpful. As most people experiance "hard" brakes not soft. And those who experianced soft brakes have the problem constantly, where is I dont.
Personally I suspect either vaccume pump or madter cylinder. Brake fluid could contain water tapped somewhere. - other than that I dont know what else it could be.
I was driving 30 mile route on country lanes (a lot of braking) when my brakes suddenly went slack. Pedal went all the way to the bottom and I had barely any brakes. ABS and Traction warning lights went on. - I stopped as soon as I could and just had to compose myself (and change underwear). I was stopped for 5 minutes or so. After which started the car and it was ok. Back to usual.
After inspectinf the engine bay I found fresh oil around vaccume pump. The fluid levels were normal. Pads and discs were only serviced a month prior to that (as part of full service).
Could anyone point me in the right direction? Googling about braking problems wasn't helpful. As most people experiance "hard" brakes not soft. And those who experianced soft brakes have the problem constantly, where is I dont.
Personally I suspect either vaccume pump or madter cylinder. Brake fluid could contain water tapped somewhere. - other than that I dont know what else it could be.
Sounds like brake fade but evidence of a fresh oil leak is obviously a concern.
Although if the levels are fine and the pedal once cool feels OK it may not be an active leak i.e. overfilled during the service.
I'd clean it all up and then pump the brake pedal a good few times and recheck the leak. If no leak have another drive and check the level regularly.
BMW brakes aren't the best and will fade with hard use. The best you can do is flush the system with fresh fluid and make sure you have good quality pads fitted.
Although if the levels are fine and the pedal once cool feels OK it may not be an active leak i.e. overfilled during the service.
I'd clean it all up and then pump the brake pedal a good few times and recheck the leak. If no leak have another drive and check the level regularly.
BMW brakes aren't the best and will fade with hard use. The best you can do is flush the system with fresh fluid and make sure you have good quality pads fitted.
You had boiled your brake fluid, but it sounds like you MAY have 2 separate issues going by other things you say, so let's start with the initial problem.
Your brake fluid got hot, boiled & caused brake fluid vapour (which is compressible) to build up & this is when you "lost your pedal".
This can be caused by fluid contamination with water, which boils at a lower temperature. Or a brake caliper issue causing the caliper to stick on & hence build up enough temperature to boil the fluid. Either way, this needs sorting URGENTLY!
Your wet master cylinder may be an enduring issue which may/may not be related or may just be left over from when the fluid was topped up last/when the pads were changed.
Most likely the fluid has been topped up when the pads were worn, and when the new pads were fitted the reservoir has over flowed & not been cleaned up.
To sort it all out:
1. Remove all calipers, check all for freedom of travel for pistons/sliders/pads etc. lubricating as required.
2. Fully change the fluid for new completely bleeding the system
3. Clean all areas to make sure any other leaks are visible.
4. Check all is good.
Your brake fluid got hot, boiled & caused brake fluid vapour (which is compressible) to build up & this is when you "lost your pedal".
This can be caused by fluid contamination with water, which boils at a lower temperature. Or a brake caliper issue causing the caliper to stick on & hence build up enough temperature to boil the fluid. Either way, this needs sorting URGENTLY!
Your wet master cylinder may be an enduring issue which may/may not be related or may just be left over from when the fluid was topped up last/when the pads were changed.
Most likely the fluid has been topped up when the pads were worn, and when the new pads were fitted the reservoir has over flowed & not been cleaned up.
To sort it all out:
1. Remove all calipers, check all for freedom of travel for pistons/sliders/pads etc. lubricating as required.
2. Fully change the fluid for new completely bleeding the system
3. Clean all areas to make sure any other leaks are visible.
4. Check all is good.
Gassing Station | BMW General | Top of Page | What's New | My Stuff


